[U-Boot] problem to boot i.MX28 custom platform

[Hector Palacios <hector.palacios@digi.com>]

Greetings,

I'm porting a custom platform based on mx28evk to latest U-Boot.
I modified the iomux.c for my platform (different DUART pins) and made some changes to 
mxs_adjust_memory_params() to accommodate to my DRAM chip.

I built the u-boot.sb. The platform however does not boot either from USB or from MMC.
When loaded through USB, sb_loader complains with the messages at [1].
I fear the CPU resets before even executing the SPL code, but how could I tell? Is 
there a way to check if the CPU reaches this code at all?
I don't see any ROM error codes either and the CPU seems to reset (when the USB 
recovery mode fails, the target defaults to boot from flash my old v2009 U-Boot).
Is there any other init stuff (linker scripts or something) I should take care of 
that's preventing sb_loader to fully load the image?

Thank you.


[1] sb_loader output

'Freescale,Inc.' 'ROM Recovery' device at USB path 0002:0034:00
Downloading 415504 bytes...
hid_write report id 01 len 0x1f

hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
.
hid_write report id 02 len 0x400
ERROR: hid_write() returned -1 (error (null))

-- 
H?ctor Palacios