From: Bo Shen <voice.shen@atmel.com>
To: u-boot@lists.denx.de
Subject: [U-Boot] [Drivers PATCH 14/19] net/macb: workaround for transmission hang issue
Date: Fri, 01 Mar 2013 11:48:09 +0800 [thread overview]
Message-ID: <513024F9.9040401@atmel.com> (raw)
In-Reply-To: <5130232F.9000002@st.com>
Hi Vipin,
On 3/1/2013 11:40, Vipin Kumar wrote:
[Snip]
>>>>> Signed-off-by: Shiraz Hashim<shiraz.hashim@st.com>
>>>>> ---
>>>>> drivers/net/macb.c | 38 ++++++++++++++++++++++++++++++++++----
>>>>> 1 file changed, 34 insertions(+), 4 deletions(-)
>>
>> Tested on Atmel EK board. It works.
>>
>> Tested-by: Bo Shen <voice.shen@atmel.com>
>>
>> BTW, would this be implemented as a workaround only for SPEAr320S?
>>
>
> Yes, The idea was to implement this only for spear320s
> After your tested-by, I am thinking may be I can make a separate
> workaround config which can be enabled by any board using this peripheral.
>
> Is that OK?
Agree.
Best Regards,
Bo Shen
next prev parent reply other threads:[~2013-03-01 3:48 UTC|newest]
Thread overview: 72+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <cover.1351876757.git.vipin.kumar@st.com>
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 01/19] mtd/st_smi: Clear error flags while initiating a fresh write Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 02/19] mtd/st_smi: Add support for Micron N25Q128 Flash Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 03/19] mtd/st_smi: Avoid issuing multiple WE commands Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 04/19] mtd/st_smi: Write to flash in a tight loop Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 05/19] mtd/st_smi: Use page sizes respective to flash Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 06/19] usbh/ehci: Increase timeout for enumeration Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 07/19] sdhci: Add sdhci support for spear devices Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 08/19] net/designware: Do not select MIIPORT for RGMII interface Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 10/19] usb/gadget/designware_otg: Add support for designware otg Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 11/19] usb/host/ehci: Add support for EHCI on spear Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 12/19] usbtty: adapt buffers for large packet support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 13/19] net/macb: Add arch specific routine to get mdio control Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [Drivers PATCH 14/19] net/macb: workaround for transmission hang issue Vipin Kumar
2013-02-03 11:19 ` Albert ARIBAUD
2013-02-28 12:59 ` Albert ARIBAUD
2013-03-01 3:08 ` Bo Shen
2013-03-01 3:40 ` Vipin Kumar
2013-03-01 3:48 ` Bo Shen [this message]
2013-03-01 3:41 ` Vipin Kumar
2013-03-01 7:28 ` Albert ARIBAUD
2013-03-01 7:55 ` Vipin Kumar
2012-11-02 17:40 ` [U-Boot] [Drivers PATCH 15/19] misc/crypto: Add support for C3 Vipin Kumar
2012-11-02 17:40 ` [U-Boot] [Drivers PATCH 16/19] armv7/ltimer: Add support for local timer on armv7 cpus Vipin Kumar
2012-11-02 17:40 ` [U-Boot] [Drivers PATCH 17/19] imls: Add support to list images in NAND device Vipin Kumar
2012-11-06 23:30 ` Scott Wood
2012-11-07 5:15 ` Vipin Kumar
2012-11-07 20:49 ` Scott Wood
2012-11-02 17:40 ` [U-Boot] [Drivers PATCH 18/19] u-boot/spl: Add u-boot-spl.img to u-boot targets Vipin Kumar
2012-11-02 17:40 ` [U-Boot] [Drivers PATCH 19/19] arm/boards: Define a new config option CONFIG_BOOT_PARAMS_P Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 1/7] spear1340: Add support for spear1340 SoC Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 2/7] spear1310: Add support for spear1310 SoC Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 3/7] spear1340evb: Add support for evb machine Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 4/7] spear1310evb: " Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 5/7] spear1340lcad: Add support for LCAD machine Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 6/7] spear1340evb: Add SPL support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr13xx PATCH 7/7] spear1310evb: " Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 1/9] spear: Add cache support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 2/9] spear3xx: Add pinmux support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 3/9] spear320plc: Correct the MACB interface Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 4/9] spear/configs: Modify several configurations Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 5/9] spear320: Add support for SD/MMC Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 6/9] spear320-hmi: Add support for hmi machine Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 7/9] spear6xx/spear3xx: Add support to boot via NAND device Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 8/9] spear/spl: Add support to boot from Parallel NOR device Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Enhancement PATCH 9/9] spear300evb: Add SPL support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 01/11] SPEAr: Remove extra spear board configurations Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 02/11] spear/configs: Split config files hierarchically into plat, arch, soc and board Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 03/11] spear/include: Clean up the spear include files Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 04/11] spear/board: Cleanup spear related board files Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 05/11] spear: Append MISC_ as prefix to misc register bitmasks Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 06/11] spear: Read ethaddr from I2C memory Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 07/11] spear: Cleanup SoC area Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 08/11] spear/spl: Cleanup spear SPL Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 09/11] spear: Add POST memory support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 10/11] spear: Enable ehci support Vipin Kumar
2012-11-02 17:39 ` [U-Boot] [SPEAr Fixes PATCH 11/11] spear3xx: FIX: Enable access to memory for spear310 and spear320 Vipin Kumar
2012-11-07 14:10 ` [U-Boot] [PATCH 00/46] Enhance spear support Stefan Roese
2012-11-08 4:58 ` Vipin Kumar
2012-11-08 4:58 ` Vipin Kumar
[not found] ` <509CD19A.2060903@st.com>
2012-11-09 11:56 ` Stefan Roese
2012-11-10 8:48 ` Albert ARIBAUD
2012-11-11 6:11 ` Stefan Roese
2012-11-11 7:50 ` Wolfgang Denk
2012-11-11 17:49 ` Albert ARIBAUD
2012-11-12 9:34 ` Armando Visconti
2012-11-12 10:35 ` Vipin Kumar
2012-11-21 9:24 ` Wolfgang Denk
2012-11-30 11:15 ` Armando Visconti
2012-11-30 12:34 ` Wolfgang Denk
2012-11-30 14:10 ` Armando Visconti
2012-12-03 5:51 ` Vipin Kumar
2012-11-20 9:46 ` Vipin Kumar
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=513024F9.9040401@atmel.com \
--to=voice.shen@atmel.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox