From mboxrd@z Thu Jan 1 00:00:00 1970 From: Vikram Narayanan Date: Tue, 02 Apr 2013 08:40:54 +0530 Subject: [U-Boot] [PATCH] Add initial support for mx6slevk board In-Reply-To: References: <1364677696-26770-1-git-send-email-festevam@gmail.com> <5159C33F.8090003@gmail.com> Message-ID: <515A4C3E.8000401@gmail.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 4/2/2013 3:45 AM, Fabio Estevam wrote: > On Mon, Apr 1, 2013 at 2:44 PM, Fabio Estevam wrote: >> On Mon, Apr 1, 2013 at 2:26 PM, Vikram Narayanan wrote: >> >>> Is the above same for all the variants of i.Mx? >>> Can we put this into a common header file? >> >> Ok, I can try to put this into a common location. >> >>>> +#define IOMUX_CONFIG_SION 0x10 >>>> +#define NO_MUX_I 0 >>>> +#define NO_PAD_I 0 >>>> +enum { >>>> + MX6_PAD_AUD_MCLK__AUDMUX_AUDIO_CLK_OUT = >>>> IOMUX_PAD(0x02A4, 0x004C, 0, 0x0000, 0, 0), >>>> + MX6_PAD_AUD_MCLK__PWM4_PWMO = >>>> IOMUX_PAD(0x02A4, 0x004C, 1, 0x0000, 0, 0), >>>> + MX6_PAD_AUD_MCLK__ECSPI3_RDY = >>>> IOMUX_PAD(0x02A4, 0x004C, 2, 0x06B4, 0, 0), >>>> + MX6_PAD_AUD_MCLK__FEC_MDC = >>>> IOMUX_PAD(0x02A4, 0x004C, 3, 0x0000, 0, 0), >>> >>> >>> Is the mx6slevk using all the pins defined here? >> >> No, I put all pins for completion. > > I meant completeness, here. > >>> If not please take off the unused IOMUX pins so that we don't add dead code. >> >> I thought it was common practice to provide the complete IOMUX pin file. > > Looking at mx6q_pins.h I see that the IOMUX table is complete, but > mx6dl_pins.h is not, so just want to get a confirmation first before > doing v2. Please refer the mx6dl discussion here. http://www.mail-archive.com/u-boot at lists.denx.de/msg94194.html It was Troy's idea, to include only the necessary pins. Regards, Vikram