[U-Boot] [PATCH v11 2/2] Enable btrfs support in mx53loco config

[Adnan Ali <adnan.ali@codethink.co.uk>]

On 02/04/13 16:19, Robert Nelson wrote:
> On Tue, Apr 2, 2013 at 9:17 AM, Adnan Ali <adnan.ali@codethink.co.uk> wrote:
>> Enable btrfs support in mx53loco config
>>
>> Signed-off-by: Adnan Ali <adnan.ali@codethink.co.uk>
>> ---
>>   include/configs/mx53loco.h |    4 +++-
>>   1 file changed, 3 insertions(+), 1 deletion(-)
>>
>> diff --git a/include/configs/mx53loco.h b/include/configs/mx53loco.h
>> index a4b610f..62e9a76 100644
>> --- a/include/configs/mx53loco.h
>> +++ b/include/configs/mx53loco.h
>> @@ -56,6 +56,8 @@
>>   #define CONFIG_GENERIC_MMC
>>   #define CONFIG_CMD_FAT
>>   #define CONFIG_CMD_EXT2
>> +#define CONFIG_CMD_BTR
>> +#define CONFIG_CMD_FS_GENERIC
>>   #define CONFIG_DOS_PARTITION
>>
>>   /* Eth Configs */
>> @@ -128,7 +130,7 @@
>>          "mmcroot=/dev/mmcblk0p3 rw rootwait\0" \
>>          "mmcargs=setenv bootargs console=ttymxc0,${baudrate} root=${mmcroot}\0" \
>>          "loadbootscript=" \
>> -               "fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
>> +               "btrload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
> Instead of changing this to btrload for everyone, wouldn't it make
> more sense to use the generic "load" command? As your already setting
> "CONFIG_CMD_FS_GENERIC"
    Well idea of adding that was to enable btrfs and to show its 
associated commands.
Yes you can use generic 'load' command. Defaults was using fatload so i 
change
it to btrload.
>
> Once you do that, you might as well also enable:
> #define CONFIG_CMD_EXT4
>
>>          "bootscript=echo Running bootscript from mmc ...; " \
>>                  "source\0" \
>>          "loaduimage=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${uimage}\0" \
>> --
>> 1.7.9.5
> Regards,
>