[U-Boot] [PATCH] mx31pdk: Remove watchdog support

[Stefano Babic <sbabic@denx.de>]

On 09/04/2013 21:03, Fabio Estevam wrote:
> The conversion of mx31pdk to SPL NAND fixed the boot issue, but we start seeing 
> resets in loop, which prevents us from reaching the U-boot prompt.
> 
> Until the proper fix can be identified, disable watchdog, so that mx31pdk
> can be functional again.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---

Hi Fabio,

>  include/configs/mx31pdk.h |    2 --
>  1 file changed, 2 deletions(-)
> 
> diff --git a/include/configs/mx31pdk.h b/include/configs/mx31pdk.h
> index 34e4295..da894c4 100644
> --- a/include/configs/mx31pdk.h
> +++ b/include/configs/mx31pdk.h
> @@ -60,8 +60,6 @@
>  
>  #define CONFIG_MXC_UART
>  #define CONFIG_MXC_UART_BASE	UART1_BASE
> -#define CONFIG_HW_WATCHDOG
> -#define CONFIG_IMX_WATCHDOG
>  #define CONFIG_MXC_GPIO
>  
>  #define CONFIG_HARD_SPI
> 

Benoit's patchset will flow into the release - then this one should also
be merged.

Acked-by: Stefano Babic <sbabic@denx.de>

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================