[U-Boot] [PATCH] make hang() a weak function

["Andreas Bießmann" <andreas.devel@googlemail.com>]

Hi Graeme,

On 04/16/2013 03:35 PM, Graeme Russ wrote:
> Hi Andreas,
> 
> On Tue, Apr 16, 2013 at 11:32 PM, Andreas Bie?mann
> <andreas.devel at googlemail.com <mailto:andreas.devel@googlemail.com>> wrote:
>>
>> Dear Wolfgang,
>>
>> On 04/16/2013 03:05 PM, Wolfgang Denk wrote:
>> > Dear Andreas,
>> >
>> > In message <516D4B00.9030102@gmail.com
> <mailto:516D4B00.9030102@gmail.com>> you wrote:

<snip>

> I think that ultimately there should only be a single hang() function

Ok.

>> > Note that hang() is not supposed to do anything else, it just hangs
>> > the system.  If you have a debugger attached, you will be able to do a
>> > simple stack backtrace and see exactly where you are hanging, and why.
>>
>> Well, for this specific board I plan to panic() on wrong hardware
>> detection (which will in turn call hang()). My requirements say that I
>> have to visualize this state then, I thought it would be a good idea to
>> blink some lights in the endless loop in hang() for this specific board.
>>
>> > If you think you need to have specialized code, you are doing
>> > something wrong.
>>
>> Really? How would you solve this requirement?
> 
> Doesn't it make  sense to use panic()?

In my opinion it makes sense to panic(). In my special case I also need
to hang() when panic(). The next question is then how to visualize the
(end-)user of that device that we hang().

Best regards

Andreas Bie?mann