[U-Boot] [PATCH v03 1/2] OMAP3+: introduce generic ABB support

[Andrii Tseglytskyi <andrii.tseglytskyi@ti.com>]

On 05/22/2013 11:56 PM, Nishanth Menon wrote:
> Hi Andrii,
> We are almost there.. minor comments follow:
> On 11:42-20130521, Andrii Tseglytskyi wrote:
> [...]
>> diff --git a/arch/arm/cpu/armv7/omap5/abb.c b/arch/arm/cpu/armv7/omap5/abb.c
>> new file mode 100644
>> index 0000000..92470be
>> --- /dev/null
>> +++ b/arch/arm/cpu/armv7/omap5/abb.c
>> @@ -0,0 +1,67 @@
> I might introduce this as part of patch #2... but no strong feelings
> about it.

I suggest to introduce OMAP5 logic in this patch. Now series is divided 
to 2 patches:

1. Control logic and needed definitions for all OMAPs -> so after this 
patch ABB can be used for OMAP3/4/5
2. ABB setup function call (in common code) and ABB registers add to 
OMAP5 data structures, so ABB will be configured for OMAP5 only in this 
case.

So, we have ->  1. complete control logic introduction + 2. using 
previously introduced logic.
I suggest to leave this as is.

> [...]
>> +s8 abb_setup_ldovbb(u32 fuse, u32 ldovbb)
>> +{
>> +	u32 vset;
>> +
>> +	/*
>> +	 * ABB parameters must be properly fused
>> +	 * otherwise ABB should be disabled
>> +	 */
>> +	vset = readl(fuse);
>> +	if (!(vset & OMAP5_ABB_FUSE_ENABLE_MASK))
>> +		return -1;
>> +
>> +	/* prepare VSET value for LDOVBB mux register */
>> +	vset &= OMAP5_ABB_FUSE_VSET_MASK;
>> +	vset >>= ffs(OMAP5_ABB_FUSE_VSET_MASK) - 1;
>> +	vset <<= ffs(OMAP5_ABB_LDOVBBMPU_VSET_OUT_MASK) - 1;
>> +	vset |= OMAP5_ABB_LDOVBBMPU_MUX_CTRL_MASK;
>> +
>> +	/* setup LDOVBB using fused value */
>> +	clrsetbits_le32(ldovbb,  OMAP5_ABB_LDOVBBMPU_VSET_OUT_MASK, vset);
> OMAP5_ABB_LDOVBBMPU_MUX_CTRL_MASK wont get set :(
> [...]
>
> Other than this, I have no further comments.