[U-Boot] [PATCH] mx6: mx6qsabrelite/nitrogen6x: Remove incorrect setting of gpio CS signal

[Dirk Behme <dirk.behme@de.bosch.com>]

On 30.05.2013 16:47, Andrew Gabbasov wrote:
> The number of gpio signal is packed inside CONFIG_SF_DEFAULT_CS macro
> (shifted and or'ed with chip select), so it's incorrect to pass
> that macro directly as an argument to gpio_direction_output() call.
>
> Also, SPI driver sets the direction and initial value of a gpio,
> used as a chip select signal, before any actual activity happens
> on the bus.
>
> So, it is safe to just remove the gpio_direction_output call,
> that works incorrectly, thus making no effect, anyway.
>
> Signed-off-by: Andrew Gabbasov <andrew_gabbasov@mentor.com>
> ---
>   board/boundary/nitrogen6x/nitrogen6x.c        |    1 -
>   board/freescale/mx6qsabrelite/mx6qsabrelite.c |    1 -
>   2 files changed, 2 deletions(-)
>
> diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c
> index cc071d6..735fd76 100644
> --- a/board/boundary/nitrogen6x/nitrogen6x.c
> +++ b/board/boundary/nitrogen6x/nitrogen6x.c
> @@ -342,7 +342,6 @@ iomux_v3_cfg_t const ecspi1_pads[] = {
>
>   void setup_spi(void)
>   {
> -	gpio_direction_output(CONFIG_SF_DEFAULT_CS, 1);
>   	imx_iomux_v3_setup_multiple_pads(ecspi1_pads,
>   					 ARRAY_SIZE(ecspi1_pads));
>   }
> diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> index 9f9cac8..29815d7 100644
> --- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> +++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> @@ -312,7 +312,6 @@ iomux_v3_cfg_t const ecspi1_pads[] = {
>
>   void setup_spi(void)
>   {
> -	gpio_direction_output(CONFIG_SF_DEFAULT_CS, 1);
>   	imx_iomux_v3_setup_multiple_pads(ecspi1_pads,
>   					 ARRAY_SIZE(ecspi1_pads));
>   }
>

Acked-by: Dirk Behme <dirk.behme@de.bosch.com>

Thanks

Dirk