[U-Boot] [PATCH v3] usb: omap: ulpi: fix ulpi transceiver access

[Michael Trimarchi <michael@amarulasolutions.com>]

Dear Marek

On 06/09/2013 10:05 PM, Marek Vasut wrote:
> Dear Michael Trimarchi,
> 
>> This patch fix the omap access to the transceiver
>> configuration registers using the ulpi bus. As reported by
>> the documentation the bit31 is used only to check if the
>> transaction is done or still running and the reading and
>> writing operation have different offset and have different
>> values. What we need to do at the end of a transaction is
>> leave the bus in done state. Anyway an error using the ulpi
>> omap register is not recoverable so any error give out the
>> usage of this interface.
>>
>> Signed-off-by: Michael Trimarchi <michael@amarulasolutions.com>
>> Reviewed-by: Igor Grinberg <grinberg@compulab.co.il>
> 
> Tom, can you ACK/NAK this ? I have no omap board.
> 

I don't understand the point, the old code was wrong and you can
check omap3/omap4 documentation. If you revert it you still have a wrong
code so it's better to drop omap3/4 viewport. 

You can take a look at this patch

http://git.omapzoom.org/?p=kernel/omap.git;a=commitdiff;h=2a18e1248588c326f0a63c5bce4a611d709130a8

that is used to fix this errata

http://git.omapzoom.org/?p=kernel/omap.git;a=commitdiff;h=a0dd0ee69578e32f1469596b8fd3a6c8ef172d42

I'm using this ulpi code in one of our device. I have fixed the u-boot viewport code because
I have seen it wrong. Sorry for the late response but I was busy for a Wedding ;), I can try
to test it tomorrow on an omap3 device but I think that is more easy for Stefano because he
has already a platform with a recent uboot

> Best regards,
> Marek Vasut
> 

Michael