[U-Boot] [PATCH 1/3] net: macb: using AT91FAMILY replace #ifdeferry

["Andreas Bießmann" <andreas.devel@googlemail.com>]

Hi Joe,

On 04/24/2013 09:59 AM, Bo Shen wrote:
> Using CONFIG_AT91FAMILY replace #ifdeferry for atmel SoC
> 
> Signed-off-by: Bo Shen <voice.shen@atmel.com>
> ---
>  drivers/net/macb.c |   10 ++--------
>  1 file changed, 2 insertions(+), 8 deletions(-)
> 
> diff --git a/drivers/net/macb.c b/drivers/net/macb.c
> index 8bacbda..753fb96 100644
> --- a/drivers/net/macb.c
> +++ b/drivers/net/macb.c
> @@ -466,19 +466,13 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
>  
>  	/* choose RMII or MII mode. This depends on the board */
>  #ifdef CONFIG_RMII
> -#if	defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
> -	defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20) || \
> -	defined(CONFIG_AT91SAM9G45) || defined(CONFIG_AT91SAM9M10G45) || \
> -	defined(CONFIG_AT91SAM9XE) || defined(CONFIG_AT91SAM9X5)
> +#ifdef CONFIG_AT91FAMILY
>  	macb_writel(macb, USRIO, MACB_BIT(RMII) | MACB_BIT(CLKEN));
>  #else
>  	macb_writel(macb, USRIO, 0);
>  #endif
>  #else
> -#if	defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
> -	defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20) || \
> -	defined(CONFIG_AT91SAM9G45) || defined(CONFIG_AT91SAM9M10G45) || \
> -	defined(CONFIG_AT91SAM9XE) || defined(CONFIG_AT91SAM9X5)
> +#ifdef CONFIG_AT91FAMILY
>  	macb_writel(macb, USRIO, MACB_BIT(CLKEN));
>  #else
>  	macb_writel(macb, USRIO, MACB_BIT(MII));
> 

just realized that this patch is still not in u-boot/master. Will you
apply it (and the rest of the series) for this release?

Best regards

Andreas Bie?mann