From mboxrd@z Thu Jan 1 00:00:00 1970 From: Troy Kisky Date: Tue, 16 Jul 2013 14:59:29 -0700 Subject: [U-Boot] i.MX6 DRAM_RESET documentation Message-ID: <51E5C241.4070901@boundarydevices.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi All I have a strange issue that maybe you can help explain. Under u-boot during a tftp transfer, we have some boards that show timeouts on our latest build, and 1 board where ethernet doesn't work at all on the latest build. These boards work with an older rev of software. I was able to compare the two versions until I found the relevant change that caused the problem. It was the setting for IOMUXC_SW_PAD_CTL_PAD_DRAM_RESET. The working code uses a value of 00b for this field. When I changed it to 11b, things broke. In the documentation, this register is defined differently for mx6q vs mv6solo/duallite. The duallite way works for the quad, and either way works for the duallite. board/boundary/nitrogen6x/ddr-setup.cfg:DATA 4, MX6_IOM_DRAM_RESET, 0x000e0030 board/freescale/imx/ddr/mx6q_4x_mt41j128.cfg:DATA 4 0x020e057c 0x00020030 Who's right? And should it depend on quad vs duallite ? Currently, I believe that the duallite documentation is correct for all. Thanks Troy IMX6DQRM-04-2013.pdf has the field defined as below IOMUXC_SW_PAD_CTL_PAD_DRAM_RESET field descriptions 31?20 : This read-only field is reserved and always has the value 0. 19?18 : DDR Select Field Select one of next values for pad: DRAM_RESET. 00 RESERVED0 ? Reserved 01 RESERVED1 ? Reserved 10 LPDDR2 ? LPDDR2 mode (240 Ohm driver unit calibration, 240, 120, 80, 60, 48, 40, 32 Ohm drive strengths at 1.2V) 11 DDR3 ? DDR3 mode (240 Ohm driver unit calibration, 240, 120, 80, 60, 48, 40, 32 Ohm drive strengths at 1.5V) ___________________________________ mx6solo-Reference Manual Addendum Rev A.2.pdf has the field defined as below IOMUXC_IOMUXC_SW_PAD_CTL_PAD_DRAM_RESET field descriptions Field Description 31?22 : This field is reserved. 21?20 : DO_TRIM Read Only Field 0 0 19?18 : DDR Select Field Select one out of next values for pad: DRAM_RESET. 00 LPDDR1 / DDR3 / (DDR2 ODT) modes 01 DDR2 driver mode 10 LPDDR2 mode 11 Reserved