[U-Boot] [U-Boot, v1, 4/8] mpc8xxx: set x2 DDR3 refresh rate if SPD config requires it

[Valentin Longchamp <valentin.longchamp@keymile.com>]

On 08/13/2013 10:24 PM, York Sun wrote:
> On 07/26/2013 03:02 AM, Valentin Longchamp wrote:
>> If the DDR3 module supports industrial temperature range and requires
>> the x2 refresh rate for that temp range, the refresh period must be
>> 3.9us instead of 7.8 us.
>>
>> Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
>>
>> ---
>> arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c | 2 ++
>>  1 file changed, 2 insertions(+)
>>
>> diff --git a/arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c b/arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c
>> index 3e7c269..603b68b 100644
>> --- a/arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c
>> +++ b/arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c
>> @@ -320,6 +320,8 @@ ddr_compute_dimm_parameters(const ddr3_spd_eeprom_t *spd,
>>  	 *       = 3.9 us at ext temperature range
>>  	 */
>>  	pdimm->refresh_rate_ps = 7800000;
>> +	if ((spd->therm_ref_opt & 0x1) && !(spd->therm_ref_opt & 0x2))
>> +		pdimm->refresh_rate_ps = 3900000;
>>  
>>  	/*
>>  	 * min four active window delay time
>>
> 
> Has this been verified on a board?

Yes, we have been using it successfully for a long time on our board.

> 
> This looks half-way done. If the module supports extended temperature
> range, the MR2 should be adjusted to fit the module.
> 

You are right, as the SPD content states it: "If SPD Byte 31 bit 0 = 1, then the
extended temperature range from 85-95 ?C is supported and the SDRAM MR2 bit A7
may be set to 1."

I will have a look at that.

Valentin