[U-Boot] [PATCH] fec_mxc: set ethaddr if fuses burned and not previously set

[Eric Nelson <eric.nelson@boundarydevices.com>]

On 08/21/2013 04:19 AM, Stefano Babic wrote:
> Hi Eric,
>
> On 02/08/2013 19:37, Eric Nelson wrote:
>> Without this change, the following message is generated:
>> 	Warning: FEC using MAC address from net device
>>
>> See doc/README.enetaddr for details.
>>
>> Signed-off-by: Eric Nelson <eric.nelson@boundarydevices.com>
>> ---
>>   drivers/net/fec_mxc.c | 2 ++
>>   1 file changed, 2 insertions(+)
>>
>> diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
>> index e14a359..886be9c 100644
>> --- a/drivers/net/fec_mxc.c
>> +++ b/drivers/net/fec_mxc.c
>> @@ -980,6 +980,8 @@ static int fec_probe(bd_t *bd, int dev_id, uint32_t base_addr,
>>   	if (fec_get_hwaddr(edev, dev_id, ethaddr) == 0) {
>>   		debug("got MAC%d address from fuse: %pM\n", dev_id, ethaddr);
>>   		memcpy(edev->enetaddr, ethaddr, 6);
>> +		if (!getenv("ethaddr"))
>> +			eth_setenv_enetaddr("ethaddr",mac);
>                                                         ^--
> of course, this should be ethaddr and not mac. I fixed it myself.
>
Thanks Stefano.