[U-Boot] [PATCH] MTD: atmel_nand: support for software BCH ECC

["Andreas Bießmann" <andreas.devel@googlemail.com>]

Hi Bo,

On 09/04/2013 02:46 PM, Bo Shen wrote:
> On 9/4/2013 8:30 PM, Andreas Bie?mann wrote:
>>> >Yes, we need libbch.
>>> >
>>> >If we really want to enable software BCH support. It also need add
>>> >following two options in board configuration file.
>>> >---8>---
>>> >#define CONFIG_NAND_ECC_BCH
>>> >#define CONFIG_BCH
>>> >---<8---
>>> >
>>> >So, this patch give us option to enable software BCH.
>> got it. So the NAND_ECC_BCH is the adoption for the SW BCH correction in
>> mtd layer. I understand that this would be helpful for at91 SoC without
>> PMECC HW. But there is no user currently, so I hesitate to apply this.
> 
> Frankly, there is no EK boards from Atmel use software BCH now, however,
> a lot of customers use NAND with 224 bytes OOB, can not use software
> ECC, they need use software BCH.

I understand this. But it will be a piece of dead code until a user of
it would be submitted.

> So, I think it is better to apply this patch. If it will break the rule
> of u-boot, then I think we can wait real user in u-boot need this and
> then apply this patch.

I'd like to hear Scott's comment on that.

Best regards

Andreas Bie?mann