From mboxrd@z Thu Jan  1 00:00:00 1970
From: Troy Kisky <troy.kisky@boundarydevices.com>
Date: Mon, 23 Sep 2013 13:55:21 -0700
Subject: [U-Boot] [PATCH V4 01/17] usb: gadget: mv_udc: don't check
	CONFIG_USB_MAX_CONTROLLER_COUNT
In-Reply-To: <5240A357.7070700@boundarydevices.com>
References: <1379647780-2623-1-git-send-email-troy.kisky@boundarydevices.com>
	<201309201245.19856.marex@denx.de>
	<523C917F.5060103@boundarydevices.com>
	<201309230205.14793.marex@denx.de>
	<5240A357.7070700@boundarydevices.com>
Message-ID: <5240AAB9.5040404@boundarydevices.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On 9/23/2013 1:23 PM, Troy Kisky wrote:
> On 9/22/2013 5:05 PM, Marek Vasut wrote:
>> Dear Troy Kisky,
>>
>>> On 9/20/2013 3:45 AM, Marek Vasut wrote:
>>>> Dear Troy Kisky,
>>>>
>>>>> i.mx6 has 1 otg controller, and 3 host ports. So,
>>>>> CONFIG_USB_MAX_CONTROLLER_COUNT can be greater than 1
>>>>> even though only 1 device mode controller is supported.
>>>>>
>>>>> Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com>
>>>> The problem is, will the 3 additional ports still work? I suspect they
>>>> will, but then if you run 'usb reset', the gadget port will also be
>>>> switched back into USB Host function, no
>>>>
>>>> Best regards,
>>>> Marek Vasut
>>> The next patch checks the OTG id before switching to host mode. If 
>>> it is
>>> grounded, then it enters
>>> host mode, otherwise it doesn't.  But, running 'usb reset' on a
>>> netconsole may kill your connection.
>> It won't if you properly ignore rhis one controller depending on the 
>> OTG pin
>> then, no ?
>>
> I can return an error code from ehci_hcd_init, so that ehci_reset will 
> not be called. But then
> usb_lowlevel_init will also return an error, which is good for the 
> call from usb_init, but bad
> for the call in usb_gadget_register_driver.
>
> Perhaps I should return a 1, instead of 0, when the otg_id pin is 
> high? And check for < 0
> before aborting from usb_gadget_register_driver ?
>
> Thanks
> Troy
>
>
>
Or maybe add a parameter to usb_lowlevel_init specifying if I desire 
host or device mode?

Thanks
Troy