[U-Boot] [PATCH 1/4] udoo: Add Ethernet support.

[Stefano Babic <sbabic@denx.de>]

Hi Giuseppe,

On 07/11/2013 13:37, Giuseppe Pagano wrote:

>>> +int mx6_rgmii_rework(struct phy_device *phydev)
>>> +{
>>> +	/* To advertise only 10 Mbs */
>>> +	phy_write(phydev, MDIO_DEVAD_NONE, 0x4, 0x61);
>>> +	phy_write(phydev, MDIO_DEVAD_NONE, 0x9, 0x0c00);
>>> +
>>
>> Why only 10 Mb/s ? I think the Micrel 9031 allows 1Gb/s.
> 
> I will check again, I remember this solves an issue present also in
> sabrelite board; but not sure. Maybe we can remove.

Ok - I know the Nitrogen (aka sabrelite) is working fine with 100Mb, I
am worrying that you will constrain the udoo to 10Mb/s

>>> +	/* min rx data delay */
>>> +	ksz9021_phy_extended_write(phydev,
>>> +				   MII_KSZ9021_EXT_RGMII_RX_DATA_SKEW, 0x0);
>>
>> Is is 9021 or 9031 ?
> 
> uDoo adopt a Micrel KSZ9031 phy. 
> Most of the register address are common to ksz9021 and ksz9031, and have
> the same value. Maybe we should rename some variable to MII_KSZ90XX_...
> 
> 
>>> +
>>> +	gpio_set_value(IMX_GPIO_NR(3, 23), 1); /* SABRE Lite PHY rst */
>>
>> SABRE as comment is maybe wrong
>>
>>> +#define CONFIG_PHY_MICREL_KSZ9021
>>
>> Ok, it is 9021 - please be consistent with the comments avoiding mixing
>> 9031 and 9021.
> 
> No, it is 9031. I will create a new define.

Mmmhh... I remember I did some work with KSZ9031 some times ago, let me see:

	http://patchwork.ozlabs.org/patch/271947/

Joe, what is the current status of that patchset ? Can you take a look
at it ?

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================