[U-Boot] [PATCH v3 2/6] arm: atmel: sama5d3: correct the error define of DIV

["Andreas Bießmann" <andreas.devel@googlemail.com>]

Hi Bo,

On 11/06/2013 06:29 AM, Bo Shen wrote:
> Correct the error define of DIV.
> 
> Signed-off-by: Bo Shen <voice.shen@atmel.com>
> 
> ---
> Changes in v3:
>   - None
> 
> Changes in v2:
>   - None
> 
>  arch/arm/include/asm/arch-at91/at91_pmc.h |    4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm/include/asm/arch-at91/at91_pmc.h b/arch/arm/include/asm/arch-at91/at91_pmc.h
> index 003920c..ed5462c 100644
> --- a/arch/arm/include/asm/arch-at91/at91_pmc.h
> +++ b/arch/arm/include/asm/arch-at91/at91_pmc.h
> @@ -124,8 +124,8 @@ typedef struct at91_pmc {
>  #define AT91_PMC_MCKR_MDIV_MASK		0x00000300
>  #endif
>  
> -#define AT91_PMC_MCKR_PLLADIV_1		0x00001000
> -#define AT91_PMC_MCKR_PLLADIV_2		0x00002000
> +#define AT91_PMC_MCKR_PLLADIV_1		0x00000000
> +#define AT91_PMC_MCKR_PLLADIV_2		0x00001000

this change will touch pm9261 board. I dunno if your change is correct
for that board. I also wonder why one should set bit position 13 in MCKR
... I can't find any source what that bit could be. However mature
documentation for sam9261 (which is the SoC on pm9261) doesn't name bit
position 12 either.

So I'm fine with your change, but please fix the pm9261 board also (use
the PLLADIV_2 define).

>  
>  #define AT91_PMC_IXR_MOSCS		0x00000001
>  #define AT91_PMC_IXR_LOCKA		0x00000002
> 

Best regards

Andreas Bie?mann