[U-Boot] [PATCH v2 1/4] udoo: Add ethernet support (FEC + Micrel KSZ9031).

[Stefano Babic <sbabic@denx.de>]

Hi Giuseppe,

On 15/11/2013 17:42, Giuseppe Pagano wrote:
> Add Ethernet and networking support on uDoo board (FEC +phy Micrel KSZ9031).
> Ethernet speed is currently limited to 10/100Mbps.
> 
> Signed-off-by: Giuseppe Pagano <giuseppe.pagano@seco.com>
> Tested-by: Fabio Estevam <fabio.estevam@freescale.com>
> CC: Stefano Babic <sbabic@denx.de>
> CC: Fabio Estevam <fabio.estevam@freescale.com>
> ---

IMHO the patch is ok. If there are not any further comments, I mark your
patchset for merging.

> +	ksz9031_phy_extended_write(phydev, 0x02,
> +				   MII_KSZ9031_EXT_RGMII_CLOCK_SKEW,
> +				   MII_KSZ9031_MOD_DATA_NO_POST_INC, 0x03FF);

I had also some issues with KSZ9031 and i.MX6. Gigabit starts working
only after setting the clock skew. I see you set the register again with
the default value (0x3FF). Because it is the reset value, it is not
required to set it again, but more important : have you make a trying
enabling Gb and adjusting only this extended register ? Rather the
KSZ9031's manual is not clear and does not say a lot about it,

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================