* [U-Boot] [PATCH 1/2] ARM: at91: at91sam9x5: mmc: save environment as a FAT file (uboot.env) @ 2013-11-22 6:58 Josh Wu 2013-11-22 6:58 ` [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat " Josh Wu 0 siblings, 1 reply; 4+ messages in thread From: Josh Wu @ 2013-11-22 6:58 UTC (permalink / raw) To: u-boot This patch will save U-Boot environment as a file: uboot.env, in FAT partition instead of saving it in raw sector of SD card. Since saving environment in raw sector has risk of corrupting the SD card and only can use very small size. Save as a FAT file has no above limitation. Signed-off-by: Josh Wu <josh.wu@atmel.com> --- include/configs/at91sam9x5ek.h | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) diff --git a/include/configs/at91sam9x5ek.h b/include/configs/at91sam9x5ek.h index ea9a50e..2cd4fae 100644 --- a/include/configs/at91sam9x5ek.h +++ b/include/configs/at91sam9x5ek.h @@ -205,11 +205,13 @@ "bootm 0x22000000" #else /* CONFIG_SYS_USE_MMC */ /* bootstrap + u-boot + env + linux in mmc */ -#define CONFIG_ENV_IS_IN_MMC -/* For FAT system, most cases it should be in the reserved sector */ -#define CONFIG_ENV_OFFSET 0x2000 -#define CONFIG_ENV_SIZE 0x1000 -#define CONFIG_SYS_MMC_ENV_DEV 0 +#define CONFIG_ENV_IS_IN_FAT +#define CONFIG_FAT_WRITE +#define FAT_ENV_INTERFACE "mmc" +#define FAT_ENV_FILE "uboot.env" +#define FAT_ENV_DEVICE 0 +#define FAT_ENV_PART 1 +#define CONFIG_ENV_SIZE 0x4000 #endif #ifdef CONFIG_SYS_USE_MMC -- 1.7.9.5 ^ permalink raw reply related [flat|nested] 4+ messages in thread
* [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat file (uboot.env) 2013-11-22 6:58 [U-Boot] [PATCH 1/2] ARM: at91: at91sam9x5: mmc: save environment as a FAT file (uboot.env) Josh Wu @ 2013-11-22 6:58 ` Josh Wu 2013-11-22 10:08 ` Bo Shen 0 siblings, 1 reply; 4+ messages in thread From: Josh Wu @ 2013-11-22 6:58 UTC (permalink / raw) To: u-boot This patch will save U-Boot environment as a file: uboot.env, in FAT partition instead of saving it in raw sector of SD card. Since saving environment in raw sector has risk of corrupting the SD card and only can use very small size. Save as a FAT file has no above limitation. Signed-off-by: Josh Wu <josh.wu@atmel.com> --- include/configs/sama5d3xek.h | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-) diff --git a/include/configs/sama5d3xek.h b/include/configs/sama5d3xek.h index 5a6f0fc..a77ab5f 100644 --- a/include/configs/sama5d3xek.h +++ b/include/configs/sama5d3xek.h @@ -196,9 +196,13 @@ "bootm 0x22000000 - 0x21000000" #elif CONFIG_SYS_USE_MMC /* bootstrap + u-boot + env in sd card */ -#define CONFIG_ENV_IS_IN_MMC -#define CONFIG_ENV_OFFSET 0x2000 -#define CONFIG_ENV_SIZE 0x1000 +#define CONFIG_ENV_IS_IN_FAT +#define CONFIG_FAT_WRITE +#define FAT_ENV_INTERFACE "mmc" +#define FAT_ENV_FILE "uboot.env" +#define FAT_ENV_DEVICE 0 +#define FAT_ENV_PART 1 +#define CONFIG_ENV_SIZE 0x4000 #define CONFIG_BOOTCOMMAND "fatload mmc 0:1 0x21000000 dtb; " \ "fatload mmc 0:1 0x22000000 uImage; " \ "bootm 0x22000000 - 0x21000000" -- 1.7.9.5 ^ permalink raw reply related [flat|nested] 4+ messages in thread
* [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat file (uboot.env) 2013-11-22 6:58 ` [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat " Josh Wu @ 2013-11-22 10:08 ` Bo Shen 2013-11-27 10:26 ` Josh Wu 0 siblings, 1 reply; 4+ messages in thread From: Bo Shen @ 2013-11-22 10:08 UTC (permalink / raw) To: u-boot Hi Josh, On 11/22/2013 02:58 PM, Josh Wu wrote: > This patch will save U-Boot environment as a file: uboot.env, in FAT partition > instead of saving it in raw sector of SD card. > > Since saving environment in raw sector has risk of corrupting the SD card and > only can use very small size. Save as a FAT file has no above limitation. > > Signed-off-by: Josh Wu <josh.wu@atmel.com> > --- > include/configs/sama5d3xek.h | 10 +++++++--- > 1 file changed, 7 insertions(+), 3 deletions(-) Tested on sama5d31ek board. It doesn't work. Please check it, and also check on at91sam9x5ek board. Please take the following information as a reference. --->8--- U-Boot 2013.10-00389-gf37e980 (Nov 22 2013 - 17:56:53) CPU: SAMA5D31 Crystal frequency: 12 MHz CPU clock : 528 MHz Master clock : 132 MHz DRAM: 512 MiB NAND: 256 MiB MMC: mci: 0 mci: setting clock 257812 Hz, block size 512 mci: setting clock 257812 Hz, block size 512 mci: setting clock 257812 Hz, block size 512 mci: setting clock 257812 Hz, block size 512 mci: setting clock 22000000 Hz, block size 512 reading uboot.env ** Unable to read "uboot.env" from mmc0:1 ** Using default environment In: serial Out: serial Err: serial Net: macb0 Warning: failed to set MAC address , usb_ether Hit any key to stop autoboot: 0 U-Boot> fat fatinfo fatload fatls fatwrite U-Boot> fatls mmc 0 20737 boot.bin 332916 u-boot.bin 2 file(s), 0 dir(s) U-Boot> saveenv Saving Environment to FAT... mci: setting clock 257812 Hz, block size 512 mci: setting clock 22000000 Hz, block size 512 mci: setting clock 257812 Hz, block size 512 mci: setting clock 257812 Hz, block size 512 mci: setting clock 22000000 Hz, block size 512 writing uboot.env done U-Boot> fatls mmc 0 20737 boot.bin 332916 u-boot.bin 2 file(s), 0 dir(s) ---8<--- > diff --git a/include/configs/sama5d3xek.h b/include/configs/sama5d3xek.h > index 5a6f0fc..a77ab5f 100644 > --- a/include/configs/sama5d3xek.h > +++ b/include/configs/sama5d3xek.h > @@ -196,9 +196,13 @@ > "bootm 0x22000000 - 0x21000000" > #elif CONFIG_SYS_USE_MMC > /* bootstrap + u-boot + env in sd card */ > -#define CONFIG_ENV_IS_IN_MMC > -#define CONFIG_ENV_OFFSET 0x2000 > -#define CONFIG_ENV_SIZE 0x1000 > +#define CONFIG_ENV_IS_IN_FAT > +#define CONFIG_FAT_WRITE > +#define FAT_ENV_INTERFACE "mmc" > +#define FAT_ENV_FILE "uboot.env" > +#define FAT_ENV_DEVICE 0 > +#define FAT_ENV_PART 1 > +#define CONFIG_ENV_SIZE 0x4000 > #define CONFIG_BOOTCOMMAND "fatload mmc 0:1 0x21000000 dtb; " \ > "fatload mmc 0:1 0x22000000 uImage; " \ > "bootm 0x22000000 - 0x21000000" > Best Regards, Bo Shen ^ permalink raw reply [flat|nested] 4+ messages in thread
* [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat file (uboot.env) 2013-11-22 10:08 ` Bo Shen @ 2013-11-27 10:26 ` Josh Wu 0 siblings, 0 replies; 4+ messages in thread From: Josh Wu @ 2013-11-27 10:26 UTC (permalink / raw) To: u-boot On 11/22/2013 6:08 PM, Bo Shen wrote: > Hi Josh, > > On 11/22/2013 02:58 PM, Josh Wu wrote: >> This patch will save U-Boot environment as a file: uboot.env, in FAT >> partition >> instead of saving it in raw sector of SD card. >> >> Since saving environment in raw sector has risk of corrupting the SD >> card and >> only can use very small size. Save as a FAT file has no above >> limitation. >> >> Signed-off-by: Josh Wu <josh.wu@atmel.com> >> --- >> include/configs/sama5d3xek.h | 10 +++++++--- >> 1 file changed, 7 insertions(+), 3 deletions(-) > > Tested on sama5d31ek board. It doesn't work. Please check it, and also > check on at91sam9x5ek board. > > Please take the following information as a reference. > --->8--- > U-Boot 2013.10-00389-gf37e980 (Nov 22 2013 - 17:56:53) > > CPU: SAMA5D31 > Crystal frequency: 12 MHz > CPU clock : 528 MHz > Master clock : 132 MHz > DRAM: 512 MiB > NAND: 256 MiB > MMC: mci: 0 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 22000000 Hz, block size 512 > reading uboot.env > > ** Unable to read "uboot.env" from mmc0:1 ** > Using default environment > > In: serial > Out: serial > Err: serial > Net: macb0 > Warning: failed to set MAC address > , usb_ether > Hit any key to stop autoboot: 0 > U-Boot> fat > fatinfo fatload fatls fatwrite > U-Boot> fatls mmc 0 > 20737 boot.bin > 332916 u-boot.bin > > 2 file(s), 0 dir(s) > > U-Boot> saveenv > Saving Environment to FAT... > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 22000000 Hz, block size 512 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 257812 Hz, block size 512 > mci: setting clock 22000000 Hz, block size 512 > writing uboot.env > done > U-Boot> fatls mmc 0 > 20737 boot.bin > 332916 u-boot.bin > > 2 file(s), 0 dir(s) > ---8<--- Oops, this indeed happened in my side too. I will follow on this issue. Thanks for the testing. > >> diff --git a/include/configs/sama5d3xek.h b/include/configs/sama5d3xek.h >> index 5a6f0fc..a77ab5f 100644 >> --- a/include/configs/sama5d3xek.h >> +++ b/include/configs/sama5d3xek.h >> @@ -196,9 +196,13 @@ >> "bootm 0x22000000 - 0x21000000" >> #elif CONFIG_SYS_USE_MMC >> /* bootstrap + u-boot + env in sd card */ >> -#define CONFIG_ENV_IS_IN_MMC >> -#define CONFIG_ENV_OFFSET 0x2000 >> -#define CONFIG_ENV_SIZE 0x1000 >> +#define CONFIG_ENV_IS_IN_FAT >> +#define CONFIG_FAT_WRITE >> +#define FAT_ENV_INTERFACE "mmc" >> +#define FAT_ENV_FILE "uboot.env" >> +#define FAT_ENV_DEVICE 0 >> +#define FAT_ENV_PART 1 >> +#define CONFIG_ENV_SIZE 0x4000 >> #define CONFIG_BOOTCOMMAND "fatload mmc 0:1 0x21000000 dtb; " \ >> "fatload mmc 0:1 0x22000000 uImage; " \ >> "bootm 0x22000000 - 0x21000000" >> > > Best Regards, > Bo Shen Best Regards, Josh Wu ^ permalink raw reply [flat|nested] 4+ messages in thread
end of thread, other threads:[~2013-11-27 10:26 UTC | newest] Thread overview: 4+ messages (download: mbox.gz follow: Atom feed -- links below jump to the message on this page -- 2013-11-22 6:58 [U-Boot] [PATCH 1/2] ARM: at91: at91sam9x5: mmc: save environment as a FAT file (uboot.env) Josh Wu 2013-11-22 6:58 ` [U-Boot] [PATCH 2/2] ARM: at91: sama5d3: mmc: save enviroment as a fat " Josh Wu 2013-11-22 10:08 ` Bo Shen 2013-11-27 10:26 ` Josh Wu
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox