From mboxrd@z Thu Jan  1 00:00:00 1970
From: Andre Przywara <andre.przywara@linaro.org>
Date: Wed, 04 Dec 2013 12:39:58 +0100
Subject: [U-Boot] upstream Arndale support
Message-ID: <529F148E.6020706@linaro.org>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi,

I cannot get upstream u-boot to run on an Arndale board. Everything 
works when I use the Linaro branch. But this tree is old and carries a 
whole different set of patches for Arndale.
Is the Arndale upstream support supposed to work? If yes, is there a 
different recipe for populating the uSD card?

What works is the following:
$ git checkout linaro
$ make arndale5250_config && make -j arndale5250
$ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
$ dd if=spl/smdk5250-spl.bin of=/dev/sdb seek=17
$ dd if=u-boot.bin of=/dev/sdb seek=49

Transferring this to upstream I get the following:
$ git checkout master
$ make arndale_config && make -j arndale
$ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
$ dd if=spl/arndale-spl.bin of=/dev/sdb seek=17
$ dd if=u-boot.bin of=/dev/sdb seek=49

However while the Linaro based build works fine, I don't get any serial 
output on the upstream build.

Can someone give any hints?

Thanks,
Andre.