From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Tue, 17 Dec 2013 17:13:43 +0100 Subject: [U-Boot] [PATCH 1/2] i.MX6 (DQ/DLS): use macros for mux and pad declarations In-Reply-To: <1384385780-11021-2-git-send-email-eric.nelson@boundarydevices.com> References: <1384385780-11021-1-git-send-email-eric.nelson@boundarydevices.com> <1384385780-11021-2-git-send-email-eric.nelson@boundarydevices.com> Message-ID: <52B07837.5020005@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 14/11/2013 00:36, Eric Nelson wrote: > This allows the use of either or both declarations from > the files mx6q_pins.h and mx6dl_pins.h. > > All board files should include > with one of the following defined in boards.cfg > MX6Q - for boards targeting i.MX6Q or i.MX6D > MX6DL - for boards targeting i.MX6DL > MX6S - for boards targeting i.MX6S > MX6QDL - for boards that support any of the above with > run-time detection > > Pad declarations will be MX6_PAD_x for single-variant boards > and MX6Q_PAD_x and MX6DL_PAD_x for boards supporting both > processor classes. > > Signed-off-by: Eric Nelson > --- Applied to u-boot-imx, sorry for delay. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================