[U-Boot] [UBOOT][PATCH 5/5] am43xx: add delay before xfer

[Sourav Poddar <sourav.poddar@ti.com>]

On Thursday 19 December 2013 11:24 AM, Jagan Teki wrote:
> On Thu, Dec 19, 2013 at 10:35 AM, Sourav Poddar<sourav.poddar@ti.com>  wrote:
>> On Thursday 19 December 2013 12:17 AM, Jagan Teki wrote:
>>> On Thu, Nov 14, 2013 at 9:09 PM, Sourav Poddar<sourav.poddar@ti.com>
>>> wrote:
>>>> Without this delay, write/read is failing.
>>>> Looks like, the WIP always remain set and hence a timeout
>>>> occurs leading to the error.
>>>>
>>>> Signed-off-by: Sourav Poddar<sourav.poddar@ti.com>
>>>> ---
>>>> Hi Jagan,
>>>> This patch seems to be necessary for read/write.
>>>> I tested by changing few timing variables, but it did not help.
>>>> The same driver works on J6 with a differnet flash(S25FL256S).
>>>> Is any one tested macronix flash at uboot?
>>> Delay must be for macronix?
>>> or common for all flashes.
>>>
>> For macronix.
> All kind of micron parts or any specific..
> bcz this delay seems to be not- a reasonable.
>
that I am not sure as I have only one macronix
flash to test with
>>> I haven't tested macronix
>>>
>>>>    drivers/spi/ti_qspi.c |    3 +++
>>>>    1 files changed, 3 insertions(+), 0 deletions(-)
>>>>
>>>> diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
>>>> index 5666250..aa7b6ae 100644
>>>> --- a/drivers/spi/ti_qspi.c
>>>> +++ b/drivers/spi/ti_qspi.c
>>>> @@ -285,6 +285,9 @@ int spi_xfer(struct spi_slave *slave, unsigned int
>>>> bitlen, const void *dout,
>>>>                   qslave->cmd |= QSPI_3_PIN;
>>>>           qslave->cmd |= 0xfff;
>>>>
>>>> +#ifdef CONFIG_AM43XX
>>>> +       udelay(100);
>>>> +#endif