[U-Boot] [PATCH] ARM: rpi_b: set $fdtfile in default environment

Albert ARIBAUD
2014-02-11T12:38:44Z

Hi Stephen,

On Mon, 10 Feb 2014 22:46:53 -0700, Stephen Warren
<swarren@wwwdotorg.org> wrote:

> On 02/04/2014 07:20 PM, Stephen Warren wrote:
> > On 01/28/2014 10:41 PM, Stephen Warren wrote:
> >> U-Boot names the Raspberry Pi board rpi_b. This means that the common
> >> expression for DTB filename ${soc}-${board}.dtb expands to
> >> bcm2835-rpi_b.dtb. However, the DTB generated by the Linux kernel is
> >> bcm2835-rpi-b.dtb. Set $fdtfile in U-Boot's environment so that scripts
> >> look for the correct DTB filename.
> >>
> >> An alternative would be to rename the U-Boot board to rpi-b. However,
> >> that change would be far more invasive, and end up affecting users (i.e
> >> they'd have to change their U-Boot build commands).
> >
> > Albert, does this look good?
>
> Albert, is this patch OK? I also haven't heard anything back on:
>
> 4a97c0d ARM: bcm2835: fix mbox POWER_STATE_RESP_ON value
> 290cc12 ARM: rpi_b: rework boot scripts, enable sysboot
> d7c3c9c ARM: rpi_b: load /uEnv.txt from MMC at startup
> bae1449 ARM: rpi_b: convert to use distro defaults
> f62463f pxe: allow compilation when !defined(CONFIG_CMD_NET)
> 11e1b89 ARM: bcm2835: config.mk isn't needed
> b5cdf43 ARM: rpi_b: set $fdtfile in default environment

This patch is OK. I'm slowly crawling through my inbox right now and
will let you know for the others as soon as I get to them.

Amicalement,
--
Albert.