[U-Boot] [PATCH] imx: sata: return failure if not IMX6Q/IMX6D

[Stefano Babic <sbabic@denx.de>]

Hi Tim,

On 05/06/2014 12:44, Tim Harvey wrote:
> On Wed, May 7, 2014 at 10:24 PM, Tim Harvey <tharvey@gateworks.com> wrote:
>> The IMX6QUAD/DUAL have SATA, but the IMX6SOLO/DL do not. Return
>> instead of configuring the SATA clock and GPR13 registers.
>>
>> Signed-off-by: Tim Harvey <tharvey@gateworks.com>
>> ---
>>  arch/arm/imx-common/sata.c | 7 ++++++-
>>  1 file changed, 6 insertions(+), 1 deletion(-)
>>
>> diff --git a/arch/arm/imx-common/sata.c b/arch/arm/imx-common/sata.c
>> index 2e69486..c10dd28 100644
>> --- a/arch/arm/imx-common/sata.c
>> +++ b/arch/arm/imx-common/sata.c
>> @@ -8,13 +8,18 @@
>>  #include <asm/arch/iomux.h>
>>  #include <asm/io.h>
>>  #include <asm/arch/clock.h>
>> +#include <asm/arch/sys_proto.h>
>>
>>  int setup_sata(void)
>>  {
>>         struct iomuxc_base_regs *const iomuxc_regs
>>                 = (struct iomuxc_base_regs *)IOMUXC_BASE_ADDR;
>> +       int ret;
>>
>> -       int ret = enable_sata_clock();
>> +       if (!is_cpu_type(MXC_CPU_MX6Q) && !is_cpu_type(MXC_CPU_MX6D))
>> +               return 1;
>> +
>> +       ret = enable_sata_clock();
>>         if (ret)
>>                 return ret;
>>
>> --
>> 1.8.3.2
>>
> 
> Stefano,
> 
> Any comments?
> 

No comments. In my queue it is ready-to-be-applied. I will do it after
the whole SPL series. My plan is to apply them until the end of the week.

Best regards,
Stefano Babic



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================