[U-Boot] [PATCH] fsl/pcie: Change 'no link' to 'undetermined' for pcie endpoint

[Roy Zang <tie-fei.zang@freescale.com>]

On 06/12/2014 10:22 PM, Prabhakar Kushwaha wrote:
>
> Hi Roy,
>
> On 6/13/2014 1:19 AM, Roy Zang wrote:
>> Even u-boot boots up, the pcie link may not setup correctly when
>> Freescale SOC acts as endpoint.
>> So change the link status from 'no link' to 'undetermined' to
>> reduce the confusion.
>> The link status can check from host side eventually.
>>
>> Signed-off-by: Roy Zang <tie-fei.zang@freescale.com>
>> ---
>>   drivers/pci/fsl_pci_init.c |   10 ++++++++--
>>   1 file changed, 8 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/pci/fsl_pci_init.c b/drivers/pci/fsl_pci_init.c
>> index 3a41b0e..231b075 100644
>> --- a/drivers/pci/fsl_pci_init.c
>> +++ b/drivers/pci/fsl_pci_init.c
>> @@ -504,8 +504,14 @@ void fsl_pci_init(struct pci_controller *hose, 
>> struct fsl_pci_info *pci_info)
>>           }
>>   #endif
>>           if (!enabled) {
>> -            /* Let the user know there's no PCIe link */
>> -            printf("no link, regs @ 0x%lx\n", pci_info->regs);
>> +            /* Let the user know there's no PCIe link for root
>> +             * complex. for endpoint, the link may not setup, so
>> +             * print undetermined.
>> +             */
>> +            if (fsl_is_pci_agent(hose))
>> +                printf("undetermined, regs @ 0x%lx\n", pci_info->regs);
>
> As description of commit message saying "The link status can check 
> from host side eventually "
> It will be good, if we can also print link status at this point to let 
> user know about status of end point.
>
however, the *no link* status prints by u-boot may not  reflect the 
final link up status. It will cause confusion.
Roy