[U-Boot] [Patch v3] Add TQ Systems TQMa6 board support

[Stefano Babic <sbabic@denx.de>]

Hi Markus,

On 10/07/2014 09:11, Markus Niebel wrote:
> Am 23.06.2014 17:56, wrote Markus Niebel:
>> From: Markus Niebel <Markus.Niebel@tq-group.com>
>>
>> This patch adds the changes to boards.cfg and the board directory
>> under board/tqc.
>>
>> TQMa6 is a family of modules based on Freescale i.MX6. It consists of
>> TQMa6Q (i.MX6 Quad), TQMa6D (i.MX6 Dual) featuring eMMC, and 1 GiB DDR3
>> TQMa6S (i.MX6 Solo)  featuring eMMC and 512 MiB DDR3
>>
>> The modules need a baseboard. Initially the MBa6x starterkit mainboard is
>> supported. To easy support for other mainboards the functionality is splitted
>> in one file for the module (tqma6.c) and one file for the baseboard (tqma6_
>> mba6).
>>
>> The modules can be boot from eMMC (on USDHC3) and SPI flash.
>>
>> The following features are supported:
>> - MMC: eMMC on module (on USDHC3) and SD-card (on MBa6x mainboard)
>> - Ethernet: RGMII using micrel KSZ9031 phy on MBa6x mainboard for TQMa6<x> module.
>>   The phy needs special configurations for the pad skew registers to adjust for
>>   the signal routing.
>>   Also support for standard ethernet commands and uppdate via tftp.
>> - SPI: ECSPI1 with bootable serial flash on module and two additional
>>   chip selects on MBa6x
>> - I2C: This patch adds support for the I2C busses on the TQMa6<x> modules (I2C3)
>>   and MBa6x baseboards (I2C1). The LM75 temperature sensors on TQMa6<x> and MBa6x
>>   are also configured.
>> - USB: high speed host 1 on MBa6x and support for USB storage
>> - PMIC: support for pfuze 100 on TQMa6<x>
>>
>> Signed-off-by: Markus Niebel <Markus.Niebel@tq-group.com>
>> ---
> 
> Ping ... any comments or shall I rebase after 2014.07 will be released?

No, please wait...I am reviewing your patch for merging into -next, even
before 2014.07 is released. If I still see open issues, I will inform you.

Thanks,
Stefano



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================