From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Thu, 10 Jul 2014 09:24:12 +0200 Subject: [U-Boot] [Patch v3] Add TQ Systems TQMa6 board support In-Reply-To: <53BE3C87.6040908@tqsc.de> References: <1403539009-14644-1-git-send-email-list-09_u-boot@tqsc.de> <53BE3C87.6040908@tqsc.de> Message-ID: <53BE3F9C.5040403@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Markus, On 10/07/2014 09:11, Markus Niebel wrote: > Am 23.06.2014 17:56, wrote Markus Niebel: >> From: Markus Niebel >> >> This patch adds the changes to boards.cfg and the board directory >> under board/tqc. >> >> TQMa6 is a family of modules based on Freescale i.MX6. It consists of >> TQMa6Q (i.MX6 Quad), TQMa6D (i.MX6 Dual) featuring eMMC, and 1 GiB DDR3 >> TQMa6S (i.MX6 Solo) featuring eMMC and 512 MiB DDR3 >> >> The modules need a baseboard. Initially the MBa6x starterkit mainboard is >> supported. To easy support for other mainboards the functionality is splitted >> in one file for the module (tqma6.c) and one file for the baseboard (tqma6_ >> mba6). >> >> The modules can be boot from eMMC (on USDHC3) and SPI flash. >> >> The following features are supported: >> - MMC: eMMC on module (on USDHC3) and SD-card (on MBa6x mainboard) >> - Ethernet: RGMII using micrel KSZ9031 phy on MBa6x mainboard for TQMa6 module. >> The phy needs special configurations for the pad skew registers to adjust for >> the signal routing. >> Also support for standard ethernet commands and uppdate via tftp. >> - SPI: ECSPI1 with bootable serial flash on module and two additional >> chip selects on MBa6x >> - I2C: This patch adds support for the I2C busses on the TQMa6 modules (I2C3) >> and MBa6x baseboards (I2C1). The LM75 temperature sensors on TQMa6 and MBa6x >> are also configured. >> - USB: high speed host 1 on MBa6x and support for USB storage >> - PMIC: support for pfuze 100 on TQMa6 >> >> Signed-off-by: Markus Niebel >> --- > > Ping ... any comments or shall I rebase after 2014.07 will be released? No, please wait...I am reviewing your patch for merging into -next, even before 2014.07 is released. If I still see open issues, I will inform you. Thanks, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================