[U-Boot] [PATCH 2/2] mx6: Adjust the GPR offset for mx6solox

[Stefano Babic <sbabic@denx.de>]

Hi Fabio,

On 09/07/2014 22:59, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam@freescale.com>
> 
> On mx6solox there is an additional 0x4000 offset for the GPR registers.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---
> This applies against 'next' branch.
> 
>  arch/arm/include/asm/arch-mx6/imx-regs.h | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/arch/arm/include/asm/arch-mx6/imx-regs.h b/arch/arm/include/asm/arch-mx6/imx-regs.h
> index 782d9c4..cc746b8 100644
> --- a/arch/arm/include/asm/arch-mx6/imx-regs.h
> +++ b/arch/arm/include/asm/arch-mx6/imx-regs.h
> @@ -398,6 +398,9 @@ struct src {
>  
>  
>  struct iomuxc {
> +#ifdef CONFIG_MX6SX
> +	u8 reserved[0x4000];
> +#endif
>  	u32 gpr[14];
>  	u32 omux[5];
>  	/* mux and pad registers */
> 

Acked-by: Stefano Babic <sbabic@denx.de>

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================