[U-Boot] [PATCH v5] mx6: add support of multi-processor command

[Stefano Babic <sbabic@denx.de>]

Hi Gabriel,

On 15/07/2014 16:13, gabriel huau wrote:

>> I have just investigate a bit. The file is included by common/board_f.c
>> but it is, frankly, quite not used. There are several prototype inside
>> it:
>>
>> void setup_mp(void);
>> void cpu_mp_lmb_reserve(struct lmb *lmb);
>> int is_core_disabled(int nr);
>>
>> They are not used at all.
>>
>> u32 determine_mp_bootpg(unsigned int *pagesize);
>>
>> This is the only one that is used.
>>
>> Then it makes more sense to drop mp.h from board_f.c and add a prototype
>> for determine_mp_bootpg(). This function is already protected by:
>>
>> #if defined(CONFIG_MP) && (defined(CONFIG_MPC86xx) ||
>> defined(CONFIG_E500))
> 
> I agree adding an empty is not necessary the best solution, but I'd
> rather not to add any cpu/board specific defines in the common/ folder.
> That's why I think we should keep CONFIG_PM as this is a generic define.
> If necessary, I can propose another patch to fix it.

I think we are saying the same thing. I agree letting CONFIG_MP, this is
not the point. But prototype for determine_mp_bootg() can be moved in a
powerpc include file and board_f does not need to include any mp.h

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================