[U-Boot] enabling ecc on P2041 and QoreIQ familly not valid for memory >= 4GB

[Benoit Sansoni <Benoit.Sansoni@kontron.com>]

York,

I am going to check out the method that you talk about.
For now the fix allow me to boot our board with 8GB it is a good step 
for me.

Thanks
Benoit

On 07/23/2014 06:32 PM, York Sun wrote:
> Benoit,
>
> If your interest is in initializing DDR for ECC, you don't have use
> dma_meminit(). There is a better and faster way to do so. All Freescale modern
> DDR controllers support this feature. All you have to do is to define these macros
>
> CONFIG_DDR_ECC
> CONFIG_ECC_INIT_VIA_DDRCONTROLLER
> CONFIG_MEM_INIT_VALUE
>
> There are plenty of example for you to follow.
>
> But again, we should fix the DMA function anyway.
>
> York
>
>
> On 07/23/2014 12:21 AM, Benoit Sansoni wrote:
>> Hi York,
>>
>> That what I saw in the code.
>>
>> Also to test it you need to have the hardware, but the evaluation board
>> P2041rdb for example does not have some ECC signals rooted for DIMM slot.
>> I validated the patch that I sent on a board based on P2041 with 8GB of
>> memory. Obviously it works with 2GB and 4GB.
>>
>> If you need help, you are welcome.
>>
>> Thanks for your help
>> Benoit
>>
>> On 07/23/2014 12:53 AM, York Sun wrote:
>>> On 07/18/2014 06:11 AM, Benoit Sansoni wrote:
>>>> Hi ,
>>>>
>>>> I found out an issue when enabling ECC for P2041 platform with an amount
>>>> of memory of 8GB.
>>>> The routine "void dma_meminit(uint val, uint size)" is not adapted to
>>>> manage memory size greater or equal to 4GB due to the 'uint' type.
>>>> With this typing the dma_meminit sees 0 as size when memory is for
>>>> example at 8GB. So the ECC part of the memory is not initialized and
>>>> when going in memory the code crash.
>>>> To correct it you need to use phys_size_t type instead of uint.
>>>> It is the same thing for all routines that are called by "dma_meminit".
>>>> I attached a patch that able to correct it easily.
>>>> This patch should be integrated in the main branch I think so.
>>>>
>>>> Regards,
>>>> Benoit
>>>>
>>> This is a valid concern. Some code started when we had far less memory. We need
>>> to comb through the code to fix more of them.
>>>
>>> York
>>>
>>>
>>
> .
>


-- 
Benoit SANSONI
Kontron Modular Computers S.A.S
150 rue Marcelin Berthelot - ZI Toulon Est - BP 244
83078 TOULON Cedex 9 - FRANCE
E-mail: benoit.sansoni at kontron.com
TEL: +33 (0)4 98 16 33 68