From mboxrd@z Thu Jan 1 00:00:00 1970 From: Przemyslaw Marczak Date: Mon, 04 Aug 2014 12:03:45 +0200 Subject: [U-Boot] [U-boot] Origen board boot failed with 2014.07 source code In-Reply-To: References: Message-ID: <53DF5A81.4080209@samsung.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello Tiger, On 07/30/2014 01:44 PM, TigerLiu at via-alliance.com wrote: > Hi, singh: > > I have an Origen(Cortex-A9 Dual Core, Exynos 4210) development > board.(InSignal produced) > > I followed below steps to verify the latest u-boot release code: > > 1. build uboot > > make origen_config > > make all > > > > then it will origen-spl.bin in spl dir. > > 2. run "dd" command to burn raw images into a SD Card. > > dd iflag=dsync oflag=dsync if=./origen-spl.bin of=/dev/sdb bs=512 The first block of SD card is reserved for a partition table. You missed seek=1 in above command - this should helps. > > dd iflag=dsync oflag=dsync if=./u-boot.bin of=/dev/sdb bs=512 seek=65 > > > > but nothing appeared in a UART terminal. > > > > Best wishes, > > > > > _______________________________________________ > U-Boot mailing list > U-Boot at lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot > Best regards, -- Przemyslaw Marczak Samsung R&D Institute Poland Samsung Electronics p.marczak at samsung.com