[U-Boot] [PATCH V2 00/18] Introduce cm-fx6 board (partial V2 cont.)

[Nikita Kiryanov <nikita@compulab.co.il>]

Hi Simon,

On 11/08/14 03:11, Simon Glass wrote:
> Hi Nikita,
>
> On 10 August 2014 11:12, Nikita Kiryanov <nikita@compulab.co.il> wrote:
>> This partial V2 completes the previous partial V2. It contains some final
>> preparational steps, and the introduction of cm-fx6 board.
>>
>> Changes in V2:
>>          - Update commit message of "arm: mx6: ddr: configure MMDC for slow_pd"
>>          - Remove unnecessary line removal from arch/arm/cpu/armv7/mx6/ddr.c
>>          - Move probe_mmdc_config() code straight to dram_init()
>>          - Use imx6_spl.h
>>          - Use imx_ddr_size()
>>            NOTE: the correction of this patch now depends on https://patchwork.ozlabs.org/patch/376095/
>
> Does this series support the dual core Utilite machine?

It does support dual core, but not the Utilite boot sequence. Right now
you can only boot from MMC because SPL has no fallback functionality and
Utilite always tries MMC first. I'll be sending patches for that after
this series is accepted.

> If so I'm not sure how to enable dual core instead of quad core - any ideas please?

You don't need to do anything to run this on dual core. ...or am I
misunderstanding your question?

>
> Regards,
> Simon
>