[U-Boot] [PATCH v2] kmp204x: reset the Zarlink clocking chips at power up only

[York Sun <yorksun@freescale.com>]

On 08/13/2014 01:17 AM, Valentin Longchamp wrote:
> There is the requirement on the chassis's backplane that when the clocks
> have been enabled, they then should not disappear.
> 
> Resetting the Zarlink clocking chips at unit reset violates this
> requirement because the backplane clocks are not supplied during the
> reset time.
> 
> To avoid this side effect, both the Zarlink clocking chips are reset
> only at power up.
> 
> Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
> 
> ---
> 
> Changes in v2:
> - Improve the commit message for more clarity
> 
>  board/keymile/kmp204x/kmp204x.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/board/keymile/kmp204x/kmp204x.c b/board/keymile/kmp204x/kmp204x.c
> index 6bc8eb8..638b2a3 100644
> --- a/board/keymile/kmp204x/kmp204x.c
> +++ b/board/keymile/kmp204x/kmp204x.c
> @@ -94,7 +94,7 @@ int board_early_init_f(void)
>  	qrio_wdmask(BFTIC4_RST, true);
>  
>  	/* set the ZL30138's prstcfg to reset at power-up and unit reset only */
> -	qrio_prstcfg(ZL30158_RST, PRSTCFG_POWUP_UNIT_RST);
> +	qrio_prstcfg(ZL30158_RST, PRSTCFG_POWUP_RST);
>  	/* and take it out of reset as soon as possible (needed for Hooper) */
>  	qrio_prst(ZL30158_RST, false, false);
>  
> @@ -144,7 +144,7 @@ int misc_init_f(void)
>  	qrio_prst(ETH_FRONT_PHY_RST, false, false);
>  
>  	/* set the ZL30343 prstcfg to reset at power-up and unit reset only */
> -	qrio_prstcfg(ZL30343_RST, PRSTCFG_POWUP_UNIT_RST);
> +	qrio_prstcfg(ZL30343_RST, PRSTCFG_POWUP_RST);
>  	/* and enable the WD on it */
>  	qrio_wdmask(ZL30343_RST, true);
>  
> 
Did you miss the comments, or they are still correct after the change?

York