[U-Boot] [PATCH 19/23] ARM: tegra: Enable PCIe on Beaver

[Stephen Warren <swarren@wwwdotorg.org>]

On 08/18/2014 01:16 AM, Thierry Reding wrote:
> From: Thierry Reding <treding@nvidia.com>
>
> The Beaver has an ethernet NIC connected to the PCIe bus. Enable the
> PCIe controller and the network device driver so that the device can
> boot over the network.
>
> In addition the board has a mini-PCIe expansion slot.

> diff --git a/arch/arm/dts/tegra30-beaver.dts b/arch/arm/dts/tegra30-beaver.dts

> +	pcie-controller {
> +		status = "okay";
> +		pex-clk-supply = <&sys_3v3_pexs_reg>;
> +		vdd-supply = <&ldo1_reg>;
> +		avdd-supply = <&ldo2_reg>;

Just like TrimSlice, there are more regulator references in the kernel DT.

The same comment applies to the next patch (i.e. the Cardhu DT patch)

> +	regulators {
...
> +		vdd_5v_in_reg: regulator at 0 {
...
> +		sys_3v3_reg: regulator at 6 {
...
> +		sys_3v3_pexs_reg: regulator at 7 {

This only adds 3 of the regulators that are in the kernel DT. Can we 
just add the whole regulators node so the two are consistent?

> diff --git a/board/nvidia/cardhu/cardhu.c b/board/nvidia/cardhu/cardhu.c

The commit description says Beaver...

I guess this should be part of the next patch, and the two swapped?