[U-Boot] [PATCH v2] imx: ddr: Move mx6q_4x_mt41j128.cfg to mx6sabresd board dir

[Stefano Babic <sbabic@denx.de>]

Hi everybody,

On 02/09/2014 01:51, Fabio Estevam wrote:
> On Mon, Sep 1, 2014 at 8:34 PM, Eric Nelson
> <eric.nelson@boundarydevices.com> wrote:
> 
>> I believe that the Wand board is using the configuration files
>> from the nitrogen6x tree.
> 
> Yes, I should have said "As it stands today only mx6qsabresd and
> congatec share the same mx6q_4x_mt41j128.cfg script."
> 

I try to sumarize the result of the discussion. This file was
factorized, but it was proofed that calibration data are very board
specific, and factorizing this file is not correct. I agree with Fabio
and Eric that it is very unlike to have the same calibration data for
different boards and the reuse of the same data is not correct.

However, with this statement the patch should also unbind the congatec
board from the sabresd, not only change the reference. A congatec
specific board must be also created in congatec/cgtqmx6eval, and it is
only a case that it has the same values of the sabresd.

Best regards,
Stefano Babic
-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================