[U-Boot] [PATCH v3 0/6] dm: Introduce driver model for sunxi

[Hans de Goede <hdegoede@redhat.com>]

Hi,

On 10/31/2014 03:25 AM, Simon Glass wrote:
> This series adds driver model support for serial and GPIO for sunxi. Since
> I only have a sun7i board to test with, I have added a new config for the
> pcDuino3, which uses device tree and driver model. This should make it
> fairly easy to enable for the other boards at some point.
> 
> This series is available at u-boot-dm/sunix-working.
> 
> Changes in v3:
> - Move enabling of 'dm' command to sunxi-common.h
> - Put enabling of DM GPIO into sunxi-common.h
> - Rebase to master
> - Move DM enable options to sunxi-common
> 
> Changes in v2:
> - Remove references to exynos and tegra
> - Use the word 'bank' instead of 'port'
> - Split non-sunxi patches into a separate dependent series
> 
> Simon Glass (6):
>   dm: sunxi: dts: Add sun7i device tree files
>   dm: sunxi: Add a new config for an FDT-based pcDuino3
>   dm: sunxi: Add pinmux functions which take a bank parameter
>   dm: sunxi: Make sure that GPIOs are requested
>   dm: sunxi: Modify the GPIO driver to support driver model
>   dm: sunxi: Add support for serial using driver model

Thanks, merged and pushed to u-boot-sunxi/next, I'm going to run some tests
now, and when those are done I'll also push this to u-boot-sunxi/master and
send a pull-req.

Regards,

Hans