From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Thu, 20 Nov 2014 10:38:47 +0100 Subject: [U-Boot] [PATCH 3/3] mx6qsabreauto: Add parallel NOR flash support In-Reply-To: <1415971643-21341-3-git-send-email-festevam@gmail.com> References: <1415971643-21341-1-git-send-email-festevam@gmail.com> <1415971643-21341-3-git-send-email-festevam@gmail.com> Message-ID: <546DB6A7.6010301@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 14/11/2014 14:27, Fabio Estevam wrote: > From: Fabio Estevam > > mx6sabreauto boards come with 32 MiB of parallel NOR flash. > > Add support for it: > > U-Boot 2015.01-rc1-18107-g1543636-dirty (Nov 14 2014 - 11:11:04) > > CPU: Freescale i.MX6Q rev1.2 at 792 MHz > Reset cause: POR > Board: MX6Q-Sabreauto revA > I2C: ready > DRAM: 2 GiB > Flash: 32 MiB > NAND: 0 MiB > > Due to pin conflict with I2C3, only define configure I2C3 IOMUX when flash is > not used. > > Signed-off-by: Fabio Estevam > --- Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================