[U-Boot] [PATCH v4 0/4] add support for new arch stv0991

[vikasm <vikas.manocha@st.com>]

Hello Simon,

On 11/18/2014 10:17 AM, vikasm wrote:
> Hello Simon,
>
> On 11/17/2014 09:19 PM, Simon Glass wrote:
>> Hi Vikas,
>>
>> On 18 November 2014 01:30, Vikas Manocha <vikas.manocha@st.com> wrote:
>>> This patchset add support for new arch stv0991.
>>>
>>> Changes in v4:
>>> - rebased to current master
>>> - added maintainers info
>>>
>>> Changes in v3:
>>> - removed period from commit messages
>>>
>>> Changes in v2:
>>> - corrected files license to GPL-2.0+
>>> - replaced printf() usage with puts() for string print
>>> - sorted sourcing of board Kconfig
>>>
>>> Vikas Manocha (4):
>>>    stv0991: Add basic stv0991 architecture support
>>>    stv0991: enable ethernet support
>>>    stv0991: default + misc command configs enabled
>>>    stv0991: add maintainer information
>> Can you please look at using driver model for this board? It would be
>> particularly valuable since it looks like you are using the pl011 UART
>> which has not previously been tested with driver model (and it seems
>> you found some problems).
>>
>> To do this you probably only need to adjust a few defines and add
>> platform data for serial. A patch for Raspberry Pi is here:
>>
>> http://patchwork.ozlabs.org/patch/392180/
>
> Sure, Simon. Infact i was also planning to use the driver model.
> Thanks for sharing the Raspberry patch link.

I tried using driver model but got into issue after relocation, figured 
out that it was because 0x0 location
was being overwritten & pl011 base address was being stored here...
After tracking "Raspberry Pi with driver model" discussion, seems like 
you are aware of it now, just wanted
to provide this information on one more platform.

Rgds,
Vikas