From mboxrd@z Thu Jan 1 00:00:00 1970 From: York Sun Date: Fri, 5 Dec 2014 08:41:42 -0800 Subject: [U-Boot] [PATCH 3/9 v2] powerpc/t1024qds: Add T1024 QDS board support In-Reply-To: <1416820321-43623-3-git-send-email-Shengzhou.Liu@freescale.com> References: <1416820321-43623-1-git-send-email-Shengzhou.Liu@freescale.com> <1416820321-43623-3-git-send-email-Shengzhou.Liu@freescale.com> Message-ID: <5481E046.90201@freescale.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 11/24/2014 01:11 AM, Shengzhou Liu wrote: > T1024QDS is a high-performance computing evaluation, development and > test platform for T1024 QorIQ Power Architecture processor. > > T1024QDS board Overview > ----------------------- > - T1024 SoC integrating two 64-bit e5500 cores up to 1.4GHz > - CoreNet fabric supporting coherent and noncoherent transactions with > prioritization and bandwidth allocation > - 32-/64-bit DDR3L/DDR4 SDRAM memory controller with ECC and interleaving support > - Accelerator: DPAA components consist of FMan, BMan, QMan, DCE and SEC > - Ethernet interfaces: > - Two 10M/100M/1G RGMII ports on-board > - Three 1G/2.5Gbps SGMII ports > - Four 1Gbps QSGMII ports > - one 10Gbps XFI or 10Base-KR interface > - SerDes: 4 lanes up to 10.3125GHz Supporting SGMII/QSGMII, XFI, PCIe, SATA and Aurora > - PCIe: Three PCI Express controllers with five PCIe slots. > - IFC: 128MB NOR Flash, 2GB NAND Flash, PromJet debug port and Qixis FPGA > - Video: DIU supports video up to 1280x1024x32 bpp. > - Chrontel CH7201 for HDMI connection. > - TI DS90C387R for direct LCD connection. > - Raw (not encoded) video connector for testing or other encoders. > - QUICC Engine block > - 32-bit RISC controller for flexible support of the communications peripherals > - Serial DMA channel for receive and transmit on all serial channels > - Two universal communication controllers, supporting TDM, HDLC, and UART > - Deep Sleep power implementaion (wakeup from GPIO/Timer/Ethernet/USB) > - eSPI: Three SPI flash devices. > - SATA: one SATA 2.O. > - USB: Two USB2.0 ports with internal PHY (one Type-A + one micro Type mini-AB) > - eSDHC: Support SD, SDHC, SDXC and MMC/eMMC. > - I2C: Four I2C controllers. > - UART: Two UART on board. > > Signed-off-by: Shengzhou Liu > --- > v2: removed diu.c by using common diu_ch7301.c > Fix ft_board_setup() type Fix MAINTAINERS for SECURE_BOOT Fix Kconfig by adding SUPPORT_SPL Applied to u-boot-mpc85xx, awaiting upstream. York