[U-Boot] [PATCH v4 0/3] pmic:pfuze support buck regulator mode switch

[Przemyslaw Marczak <p.marczak@samsung.com>]

Hello Peng,

On 01/16/2015 05:05 PM, Peng Fan wrote:
> Hi, Przemyslaw
>
> There is a few return value comments that from Fabio, I correct them and
> send out v4 version. Others are same to the v1 version patch set. If
> this patch set is fine, please give you Acked-by. Sorry for the troubles.

No troubles, just normal review process:)

>
> This patch set is to support buck regulator can
> working in different switching modes. To improve
> system efficiency the buck regulators can operate
> in different switching modes.
>
> patch 1/3 is to add related bit definitions and registers.
> patch 2/3 is to implement the switching mode init function.
> patch 3/3 is to add related mode init function in board code.
>
> mx6slevk board is not included in this patch set, since power
> and i2c interface are not implemented for it. Future patch will
> cover this to add PAD setting, power_init_board and etc.
>
>
> Peng Fan (3):
>    pmic:pfuz100 add switch mode and more registers
>    pmic:pfuze implement pmic_mode_init
>    imx:mx6 set normal APS and standby PFM mode
>
>   board/freescale/common/pfuze.c                | 36 ++++++++++++++++++
>   board/freescale/common/pfuze.h                |  1 +
>   board/freescale/mx6qsabreauto/mx6qsabreauto.c |  6 +++
>   board/freescale/mx6sabresd/mx6sabresd.c       |  6 ++-
>   board/freescale/mx6sxsabresd/mx6sxsabresd.c   |  6 ++-
>   include/power/pfuze100_pmic.h                 | 53 +++++++++++++++++++++++++++
>   6 files changed, 106 insertions(+), 2 deletions(-)
>

For the series, Acked-by: Przemyslaw Marczak <p.marczak@samsung.com>

Best regards,
-- 
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
p.marczak at samsung.com