[U-Boot] [PATCH v2] ARM: atmel: at91sam9m10g45ek: enable SPL

[Bo Shen <voice.shen@atmel.com>]

Hi Heiko,

On 01/21/2015 07:01 PM, Heiko Schocher wrote:
> Hello Bo,
>
> Am 21.01.2015 10:45, schrieb Bo Shen:
>> Supports boot up from NAND flash with software ECC eanbled.
>> And supports boot up from SD/MMC card with FAT file system.
>>
>> As the boot from SD/MMC card with FAT file system, the BSS
>> segment is too big to fit into SRAM, so, use the lds to put
>> it into SDRAM.
>>
>> Signed-off-by: Bo Shen <voice.shen@atmel.com>
>> ---
>>
>> Changes in v2:
>>    - This patch based on one patch from Simon Glass
>>      - http://patchwork.ozlabs.org/patch/430240/
>>    - remove the low level init code.
>>    - correct the stack of corvus board.
>
> You do not change, nor need to change now with the patch from Simon
> something for the corvus board!

Oops, forget to remove the last line.

> Beside of that:
>
> Acked-by: Heiko Schocher <hs@denx.de>

Thanks.

> bye,
> Heiko

Best Regards,
Bo Shen