[U-Boot] [v3 PATCH 1/3] arm: mxs: Add debug outputs and comments to mxs SPL source files

[Stefano Babic <sbabic@denx.de>]

On 25/01/2015 02:07, Graeme Russ wrote:
> It is difficult to track down fail to boot issues in the mxs SPL.
> Implement the following to make it easier:
>  - Add debug outputs to allow tracing of SPL progress in order to track
> where failure to boot occurs. DEUBUG and CONFIG_SPL_SERIAL_SUPPORT must
> be defined to enable debug output in SPL
>  - Add TODO comments where it is not clear if the code is doing what it
> is meant to be doing, even tough the board boots properly (these comments
> refer to existing code, not to any code added by this patch)
> 
> Signed-off-by: Graeme Russ <gruss@tss-engineering.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================