From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Wed, 11 Feb 2015 15:16:50 +0100 Subject: [U-Boot] relocation on freescale mx35 doesn't work after update to 2015.01 In-Reply-To: References: Message-ID: <54DB6452.2050100@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Fabio, On 11/02/2015 14:55, Fabio Estevam wrote: > Hi Stefano, > > On Thu, Feb 5, 2015 at 1:24 PM, Priebe, Sebastian > wrote: >> Hello, >> >> I'm using a custom board with iMX35 CPU (ARM1136). >> After I updated to version 2015.01 the relocation doesn't work anymore. >> I turned on CONFIG_DEBUG and the last output I saw was: >> Relocating to 83f89000, new gd at 83e84ec8, sp at 83e84ea0 >> >> I recognized the new function "relocate_vectors". >> I copied the special handling (strong function) from mx25, which is just skipping the relocation of the vectors and with that the U-Boot is booting again on my board. >> >> Do I need some special handling for mx35, too? Does anyone have the same problem? > > I don't have a mx35pdk handy to look into this, but it would be nice > to get mx35 back to life in U-boot. > Of course, yes. I have rather no time to look into, maybe someone else can take a look. > Magnus, > > I suspect that mx31 is also broken. Could you please test mx31pdk with > U-boot 2015.01? > Stefano -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================