[U-Boot] [PATCH] arm: mx5: Add support for USB armory board

[Stefano Babic <sbabic@denx.de>]

Hi Fabio, Eric,

On 17/03/2015 17:51, Eric Nelson wrote:
> Hi Fabio,
> 
> On 03/17/2015 09:30 AM, Fabio Estevam wrote:
>> On Mon, Mar 16, 2015 at 1:50 PM, Chris Kuethe <chris.kuethe@gmail.com> wrote:
>>
>>> U-Boot 2015.04-rc3-00209-ga74ef40-dirty (Mar 15 2015 - 22:04:22)
>>>
>>> CPU:   Freescale i.MX53 rev2.1 at 800 MHz
>>> Reset cause: WDOG
>>
>> Here the reset cause is printed correctly.
>>
>>> Board: Inverse Path USB armory MkI
>>> I2C:   ready
>>> DRAM:  512 MiB
>>> MMC:   FSL_SDHC: 0
>>> In:    serial
>>> Out:   serial
>>> Err:   serial
>>> CPU:   Freescale i.MX53 rev2.1 at 800 MHz
>>> Reset cause: unknown reset
>>
>> ,but here it fails.
>>
>> Why does CPU version and reset cause are printed twice?
>>
> 

The arm library calls always print_cpuinfo(), where get_reset_cause() is
called. In this patch, print_cpuinfo() is called the second time in
board_late_init(), too. It should be dropped.

Without testing, I think that this issue hits the mx53loco, too.

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================