From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Wed, 08 Apr 2015 10:46:42 +0200 Subject: [U-Boot] [PATCH] mx53loco: Disable printing cpuinfo In-Reply-To: <1428330187-10256-1-git-send-email-fabio.estevam@freescale.com> References: <1428330187-10256-1-git-send-email-fabio.estevam@freescale.com> Message-ID: <5524EAF2.8060103@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 06/04/2015 16:23, Fabio Estevam wrote: > Since commit 32df39c741788e ("mx5: fix get_reset_cause") we have the following > boot messages on a mx53qsb: > > U-Boot 2015.04-rc5-00029-gd68df02 (Apr 06 2015 - 11:15:39) > > CPU: Freescale i.MX53 rev2.1 at 800 MHz > Reset cause: POR > Board: MX53 LOCO > I2C: ready > DRAM: 1 GiB > MMC: FSL_SDHC: 0, FSL_SDHC: 1 > In: serial > Out: serial > Err: serial > CPU: Freescale i.MX53 rev2.1 at 1000 MHz > Reset cause: unknown reset > Net: FEC [PRIME] > > The CPU and Reset cause lines appear twice. > > Initially mx53 boots at 800MHz, then at a later point the PMIC is configured via > I2C to raise the CPU voltage so that it can run at 1GHz. > > To avoid such misleading double printings, disable printing cpu info for now. > > Signed-off-by: Fabio Estevam > --- Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================