[U-Boot] [PATCH v3] powerpc/t1040qds: Add support of SD boot for T1040QDS Board

[York Sun <yorksun@freescale.com>]

On 02/13/2015 07:25 AM, Vijay Rai wrote:
> Add support of 2 stage SD boot loader using SPL framework.
> here, PBL initialise the internal SRAM and copy SPL(160KB). This further
> initialise DDR using SPD environment and copy u-boot(768 KB) from NAND to DDR.
> Finally SPL transer control to u-boot.
> 
> Initialise/create followings required for SPL framework
>       - Add spl.c which defines board_init_f, board_init_r
>       - Update tlb and ddr accordingly
> 
> Add T1040QDS_SDCARD_defconfig
> Update t1040_pbi.cfg to support errata A-007662, A-008007 and LAW for CPC1
> 
> Signed-off-by: Vijay Rai <vijay.rai@freescale.com>
> Signed-off-by: Priyanka Jain <Priyanka.Jain@freescale.com>
> ---
> changes from v2:
>  - Updated Copyright to 2015
>  - Updated board_need_mem_reset, now it resets DDR by default, earlier
>    it was disabling the reset for NOR boot which is wrong
>  - tested NOR boot and SD boot 
> 

Please rebase your patch and test. I see compiling errors and warnings.

York