[U-Boot] [PATCH v2 3/4] imx: mx6: add display of CPU temperature grade in print_cpuinfo()

[Stefano Babic <sbabic@denx.de>]

Hi Tim,

On 15/05/2015 15:31, Tim Harvey wrote:

>> Right. My proposal is to merge the currrent patchset, enabling for
>> IMX6SX again when someone will test it.
>>
>> Best regards,
>> Stefano Babic
>>
> 
> Stefano,
> 
> Yes, that sounds like the best approach. What were your thoughts on
> enabling the second CPU: line just to display the temperature grade if
> CONFIG_IMX6_THERMAL was not enabled?

As you said, printing a lot can be disturbing for someone, and letting
the possibility to turn out prints is not bad. I will let the board
maintainer to decide it.

> 
> I'm surprised someone on this list hasn't already tested this on IMX6SX.
> 

I am quite convinced that patches are tested by a few until they are
merged. If there is a ready-to-use tree, people are more motivated to
test it.

> Fabio - certainly you must have a reference board with an IMX6SX and
> could enable/test that the CPU markings agree with what is
> detected/displayed via OTP?
> 

Of course, I could delay for applying this patchset if Fabio / someone
has the possibility to test it with 6X. Anyway, running on 6X is
protected by the check on the cpu, and I do not see problems to merge it.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================