[U-Boot] [PATCH 2/2] sunxi: Make dram odt-en configurable through Kconfig for A33 based boards

[Hans de Goede <hdegoede@redhat.com>]

Hi,

On 14-05-15 20:41, Ian Campbell wrote:
> On Thu, 2015-05-14 at 18:55 +0200, Hans de Goede wrote:
>>>> +config DRAM_ODT_EN
>>>> +	int "sunxi dram odt enable"
>>>> +	default 0
>>>> +	---help---
>>>> +	Set this to 1 to enable dram odt (on die termination)
>>>
>>> Why is this an int rather than a bool?
>>
>> Because it is used directly as an int in the code, otherwise I
>> need to add #ifdef-ery. I guess I could make it a bool and use
>> IS_ENABLED(), but that does lead to slightly less readable code
>> IMHO.
>
> I'm afraid I think IS_ENABLED is the way to go though, it's the lesser
> of two evils compared with using an int for a boolean option.

Ok, so while trying to fix this I noticed that there already is a
definition of CONFIG_DRAM_ODT_EN in board/sunxi/Kconfig inside a

#if MACH_SUN4I || MACH_SUN5I || MACH_SUN7I

block, and that one actually really is an int (it goes from 0-3).
so I'm going to leave this as an int, and use the existing option
moving it outside of the #if MACH_SUN4I || MACH_SUN5I || MACH_SUN7I
block.

v2 coming up.

Regards,

Hans