* [U-Boot] Fwd: Re: sd card not working.
[not found] <558D5B2F.3070402@uclv.cu>
@ 2015-06-26 14:08 ` Alexy Gallardo Segura
0 siblings, 0 replies; only message in thread
From: Alexy Gallardo Segura @ 2015-06-26 14:08 UTC (permalink / raw)
To: u-boot
hi Jaehoon Chung
in the previous email I try to reduce search of error. This is the
seriel output with enabled CONFIG_MMC_TRACE.
U-Boot 2015.04-rc2 (Jun 26 2015 - 09:46:24)
CPU: Exynos4412 at 1000MHz
Model: Odroid based on Exynos4412
DRAM: 2 GiB
Board PMIC init
MMC: SAMSUNG SDHCI: 0, EXYNOS DWMMC: 1
CMD_SEND:0
ARG 0x00000000
MMC_RSP_NONE
CMD_SEND:8
ARG 0x000001AA
MMC_RSP_R1,5,6,7 0x000001AA
CMD_SEND:55
ARG 0x00000000
MMC_RSP_R1,5,6,7 0x00000120
CMD_SEND:41
ARG 0x40300000
MMC_RSP_R3,4 0x00FF8000
CMD_SEND:55
ARG 0x00000000
MMC_RSP_R1,5,6,7 0x00000120
CMD_SEND:41
ARG 0x40300000
MMC_RSP_R3,4 0xC0FF8000
CMD_SEND:2
ARG 0x00000000
MMC_RSP_R2 0x744A4553
0x44432020
0x1033005B
0x8700E100
DUMPING DATA
000 - 74 4A 45 53
004 - 44 43 20 20
008 - 10 33 00 5B
012 - 87 00 E1 00
CMD_SEND:3
ARG 0x00000000
MMC_RSP_R1,5,6,7 0xB3680520
CMD_SEND:9
ARG 0xB3680000
MMC_RSP_R2 0x400E0032
0x5B590000
0x3C1D7F80
0x0A400000
DUMPING DATA
000 - 40 0E 00 32
004 - 5B 59 00 00
008 - 3C 1D 7F 80
012 - 0A 40 00 00
CMD_SEND:13
ARG 0xB3680000
MMC_RSP_R1,5,6,7 0x00000700
CURR STATE:3
CMD_SEND:7
ARG 0xB3680000
MMC_RSP_R1,5,6,7 0x00000700
CMD_SEND:55
ARG 0xB3680000
MMC_RSP_R1,5,6,7 0x00000920
CMD_SEND:51
ARG 0x00000000
MMC_RSP_R1,5,6,7 0x00000920
CMD_SEND:6
ARG 0x00FFFFF1
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:6
ARG 0x80FFFFF1
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:55
ARG 0xB3680000
MMC_RSP_R1,5,6,7 0x00000920
CMD_SEND:6
ARG 0x00000002
MMC_RSP_R1,5,6,7 0x00000920
CMD_SEND:16
ARG 0x00000200
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:17
ARG 0x00000000
sdhci_transfer_data: Error detected in status(0x208002)!
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:16
ARG 0x00000200
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:17
ARG 0x00000000
sdhci_transfer_data: Error detected in status(0x208002)!
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:16
ARG 0x00000200
MMC_RSP_R1,5,6,7 0x00000900
CMD_SEND:18
ARG 0x00000A00
sdhci_transfer_data: Error detected in status(0x608000)!
MMC_RSP_R1,5,6,7 0x00000900
Using default environment
DFU alt info setting: done
Net: No ethernet found.
Hit any key to stop autoboot: 0
best regards
Alexy
On 06/26/2015 12:09 AM, Jaehoon Chung wrote:
> Hi, Alexy.
>
> On 06/25/2015 09:56 PM, Alexy Gallardo Segura wrote:
>> hi Jaehoon Chung
>>
>> I use the CONFIG_MMC_TRACE in the method
>> static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data,
>> unsigned int start_addr)
>> on file sdhci.c.
> How did you use the CONFIG_MMC_TRACE?
> If CONFIG_MMC_TRACE is enabled, it should be printed messages in mmc.c.
> (Try to print all debug messages.)
> Then we can check which command is error. I will try to reproduce this.
>
> Best Regards,
> Jaehoon Chung
>
>> This is the output for debug of method. This output is using the CONFIG_MMC_TRACE for complete method :
>>
>> CPU: Exynos4412 at 1000MHz
>> Model: Odroid based on Exynos4412
>> DRAM: 2 GiB
>> Board PMIC init
>> MMC: SAMSUNG SDHCI: 0, EXYNOS DWMMC: 1
>> mmc fail to send stop cmd
>> Using default environment
>>
>> DFU alt info setting: done
>> Net: No ethernet found.
>> Hit any key to stop autoboot: 0
>> Failed to mount ext2 filesystem...
>> ** Unrecognized filesystem type **
>> mmc fail to send stop cmd
>> ** ext4fs_devread read error - block
>> Failed to mount ext2 filesystem...
>> ** Unrecognized filesystem type **
>> Failed to mount ext2 filesystem...
>> ** Unrecognized filesystem type **
>>
>> For the CONFIG_MMC_TRACE for the part of method where is throws the error the serial output is the next:
>>
>> CPU: Exynos4412 at 1000MHz
>> Model: Odroid based on Exynos4412
>> DRAM: 2 GiB
>> Board PMIC init
>> MMC: SAMSUNG SDHCI: 0, EXYNOS DWMMC: 1
>> sdhci_transfer_data: Transfer data timeout
>> sdhci_transfer_data: Transfer data timeout
>> MMC init failed
>> Using default environment
>>
>> DFU alt info setting: done
>> Net: No ethernet found.
>> Hit any key to stop autoboot: 0
>> sdhci_transfer_data: Transfer data timeout
>> ** Bad device mmc 0 **
>> sdhci_transfer_data: Transfer data timeout
>> ** Bad device mmc 0 **
>> sdhci_transfer_data: Transfer data timeout
>> ** Bad device mmc 0 **
>> Odroid #
>>
>> best regards
>>
>> Alexy
>>
>> On 06/24/2015 09:41 PM, Jaehoon Chung wrote:
>>> Hi, Alexy.
>>>
>>> On 06/25/2015 02:06 AM, Alexy Gallardo Segura wrote:
>>>> Hello everyone
>>>>
>>>> I am currently working with the ODROID-x2 platform and the U-boot that was using the u-boot by default, but support for the USB driver does not work well. Then I started to use the version available at:
>>>>
>>>> https://github.com/LeMaker/u-boot
>>>>
>>>> The USB works well. Probe the network and SD_CARD memories but now is not working for me. I am using an SD 8Gb.
>>>>
>>>> Serious output is as follows:
>>>>
>>>> U-Boot 2015.04-rc2 (Jun 24 2015 - 10:24:52)
>>>>
>>>> CPU: Exynos4412 at 1000MHz
>>>> Model: Odroid based on Exynos4412
>>>> DRAM: 2 GiB
>>>> Board PMIC init
>>>> MMC: SAMSUNG SDHCI: 0, EXYNOS DWMMC: 1
>>>> sdhci_transfer_data: Error detected in status(0x208002)!
>>>> sdhci_transfer_data: Error detected in status(0x208002)!
>>>> sdhci_transfer_data: Error detected in status(0x208000)!
>>>> Using default environment
>>> It seems that sd-card doesn't initialize completely.
>>> -> "sdhci_transfer_data: Error detected in status(0x208000)!"
>>>
>>> You can enable the MMC debug configuration.(CONFIG_MMC_TRACE)
>>> Could you share the log message after enable CONFIG_MMC_TRACE?
>>>
>>> Best Regards,
>>> Jaehoon Chung
>>>
>>>> DFU alt info setting: done
>>>> Net: No ethernet found.
>>>> Hit any key to stop autoboot: 0
>>>> ** ext4fs_devread read error - block
>>>> Failed to mount ext2 filesystem...
>>>> ** Unrecognized filesystem type **
>>>> ** ext4fs_devread read error - block
>>>> Failed to mount ext2 filesystem...
>>>> ** Unrecognized filesystem type **
>>>> ** ext4fs_devread read error - block
>>>> Failed to mount ext2 filesystem...
>>>> ** Unrecognized filesystem type **
>>>> Odroid #
>>>>
>>>> if someone knows something and I can help.
>>>>
>>>> Regards
>>>>
>>>> Alexy
>>>> _______________________________________________
>>>> U-Boot mailing list
>>>> U-Boot at lists.denx.de
>>>> http://lists.denx.de/mailman/listinfo/u-boot
>>>>
>>
^ permalink raw reply [flat|nested] only message in thread