[U-Boot] [PATCH 01/12] arm: mx6: cm-fx6: map HDMI to IPU1 DI0 explicitly

[Stefano Babic <sbabic@denx.de>]

On 23/07/2015 16:19, Nikita Kiryanov wrote:
> U-Boot does not explicitly assign the display to an IPU interface. Instead, it
> relies on the power-on default of DI0.
> 
> Since the kernel reassigns HDMI display to DI1, after a warm reset the HDMI
> display no longer works in U-Boot.
> 
> Fix this by explicitly assigning HDMI to IPU1 DI0 in U-Boot.
> 
> Cc: Stefano Babic <sbabic@denx.de>
> Cc: Igor Grinberg <grinberg@compulab.co.il>
> Signed-off-by: Nikita Kiryanov <nikita@compulab.co.il>
> ---
>  board/compulab/cm_fx6/cm_fx6.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c
> index 7a1bbaf..b500f91 100644
> --- a/board/compulab/cm_fx6/cm_fx6.c
> +++ b/board/compulab/cm_fx6/cm_fx6.c
> @@ -83,6 +83,7 @@ size_t display_count = ARRAY_SIZE(displays);
>  static void cm_fx6_setup_display(void)
>  {
>  	struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
> +	struct iomuxc *const iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
>  	int reg;
>  
>  	enable_ipu_clock();
> @@ -90,6 +91,7 @@ static void cm_fx6_setup_display(void)
>  	reg = __raw_readl(&mxc_ccm->CCGR3);
>  	reg |= MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK;
>  	writel(reg, &mxc_ccm->CCGR3);
> +	clrbits_le32(&iomuxc_regs->gpr[3], MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK);
>  }
>  #else
>  static inline void cm_fx6_setup_display(void) {}
> 

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================